@@ -123,8 +123,13 @@
#size-cells = <0>;
ethphy0: ethernet-phy@0 { /* SMSC LAN8710Ai */
- reg = <0>;
+ compatible = "ethernet-phy-ieee802.3-c22";
+ interrupt-parent = <&gpio4>;
+ interrupts = <15 IRQ_TYPE_LEVEL_LOW>;
max-speed = <100>;
+ pinctrl-0 = <&pinctrl_ethphy0>;
+ pinctrl-names = "default";
+ reg = <0>;
reset-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>;
reset-assert-us = <1000>;
reset-deassert-us = <1000>;
@@ -298,8 +303,6 @@
MX6QDL_PAD_ENET_TXD0__ENET_TX_DATA0 0x1b0b0
MX6QDL_PAD_ENET_TXD1__ENET_TX_DATA1 0x1b0b0
MX6QDL_PAD_GPIO_16__ENET_REF_CLK 0x4001b0a8
- MX6QDL_PAD_EIM_WAIT__GPIO5_IO00 0x000b0
- MX6QDL_PAD_KEY_ROW4__GPIO4_IO15 0x000b1
>;
};
@@ -309,6 +312,13 @@
>;
};
+ pinctrl_ethphy0: ethphy0-grp {
+ fsl,pins = <
+ MX6QDL_PAD_EIM_WAIT__GPIO5_IO00 0xb0 /* Reset */
+ MX6QDL_PAD_KEY_ROW4__GPIO4_IO15 0xb1 /* Int */
+ >;
+ };
+
pinctrl_flexcan1: flexcan1-grp {
fsl,pins = <
MX6QDL_PAD_KEY_COL2__FLEXCAN1_TX 0x1b0b0
Enable the interrupt mode for the ethernet PHY by adding the necessary property and a separate pinctrl for the PHY. Also add the compatible property for it. Signed-off-by: Christoph Niedermaier <cniedermaier@dh-electronics.com> Cc: Shawn Guo <shawnguo@kernel.org> Cc: Fabio Estevam <festevam@gmail.com> Cc: Marek Vasut <marex@denx.de> Cc: NXP Linux Team <linux-imx@nxp.com> Cc: kernel@dh-electronics.com To: linux-arm-kernel@lists.infradead.org --- arch/arm/boot/dts/imx6q-dhcom-som.dtsi | 16 +++++++++++++--- 1 file changed, 13 insertions(+), 3 deletions(-)