@@ -1,3 +1,4 @@
# SPDX-License-Identifier: GPL-2.0-only
obj-$(CONFIG_ACPI_IORT) += iort.o
obj-$(CONFIG_ACPI_GTDT) += gtdt.o
+obj-y += dma.o
@@ -259,9 +259,12 @@ void acpi_numa_x2apic_affinity_init(struct acpi_srat_x2apic_cpu_affinity *pa);
#ifdef CONFIG_ARM64
void acpi_numa_gicc_affinity_init(struct acpi_srat_gicc_affinity *pa);
+void acpi_arch_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size);
#else
static inline void
acpi_numa_gicc_affinity_init(struct acpi_srat_gicc_affinity *pa) { }
+static inline void
+acpi_arch_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size) { }
#endif
int acpi_numa_memory_affinity_init (struct acpi_srat_mem_affinity *ma);
@@ -34,7 +34,7 @@ struct irq_domain *iort_get_device_domain(struct device *dev, u32 id,
void acpi_configure_pmsi_domain(struct device *dev);
int iort_pmsi_get_dev_id(struct device *dev, u32 *dev_id);
/* IOMMU interface */
-void iort_dma_setup(struct device *dev, u64 *dma_addr, u64 *size);
+int iort_dma_get_ranges(struct device *dev, u64 *size);
const struct iommu_ops *iort_iommu_configure_id(struct device *dev,
const u32 *id_in);
int iort_iommu_msi_get_resv_regions(struct device *dev, struct list_head *head);
@@ -48,8 +48,8 @@ static inline struct irq_domain *iort_get_device_domain(
{ return NULL; }
static inline void acpi_configure_pmsi_domain(struct device *dev) { }
/* IOMMU interface */
-static inline void iort_dma_setup(struct device *dev, u64 *dma_addr,
- u64 *size) { }
+static inline int iort_dma_get_ranges(struct device *dev, u64 *size)
+{ return -ENODEV; }
static inline const struct iommu_ops *iort_iommu_configure_id(
struct device *dev, const u32 *id_in)
{ return NULL; }
new file mode 100644
@@ -0,0 +1,50 @@
+// SPDX-License-Identifier: GPL-2.0-only
+#include <linux/acpi.h>
+#include <linux/acpi_iort.h>
+#include <linux/device.h>
+#include <linux/dma-direct.h>
+
+void acpi_arch_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size)
+{
+ int ret;
+ u64 end, mask;
+ u64 dmaaddr = 0, size = 0, offset = 0;
+
+ /*
+ * If @dev is expected to be DMA-capable then the bus code that created
+ * it should have initialised its dma_mask pointer by this point. For
+ * now, we'll continue the legacy behaviour of coercing it to the
+ * coherent mask if not, but we'll no longer do so quietly.
+ */
+ if (!dev->dma_mask) {
+ dev_warn(dev, "DMA mask not set\n");
+ dev->dma_mask = &dev->coherent_dma_mask;
+ }
+
+ if (dev->coherent_dma_mask)
+ size = max(dev->coherent_dma_mask, dev->coherent_dma_mask + 1);
+ else
+ size = 1ULL << 32;
+
+ ret = acpi_dma_get_range(dev, &dmaaddr, &offset, &size);
+ if (ret == -ENODEV)
+ ret = iort_dma_get_ranges(dev, &size);
+ if (!ret) {
+ /*
+ * Limit coherent and dma mask based on size retrieved from
+ * firmware.
+ */
+ end = dmaaddr + size - 1;
+ mask = DMA_BIT_MASK(ilog2(end) + 1);
+ dev->bus_dma_limit = end;
+ dev->coherent_dma_mask = min(dev->coherent_dma_mask, mask);
+ *dev->dma_mask = min(*dev->dma_mask, mask);
+ }
+
+ *dma_addr = dmaaddr;
+ *dma_size = size;
+
+ ret = dma_direct_set_offset(dev, dmaaddr + offset, dmaaddr, size);
+
+ dev_dbg(dev, "dma_offset(%#08llx)%s\n", offset, ret ? " failed!" : "");
+}
@@ -1144,56 +1144,18 @@ static int rc_dma_get_range(struct device *dev, u64 *size)
}
/**
- * iort_dma_setup() - Set-up device DMA parameters.
+ * iort_dma_get_ranges() - Look up DMA addressing limit for the device
+ * @dev: device to lookup
+ * @size: DMA range size result pointer
*
- * @dev: device to configure
- * @dma_addr: device DMA address result pointer
- * @dma_size: DMA range size result pointer
+ * Return: 0 on success, an error otherwise.
*/
-void iort_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size)
+int iort_dma_get_ranges(struct device *dev, u64 *size)
{
- u64 end, mask, dmaaddr = 0, size = 0, offset = 0;
- int ret;
-
- /*
- * If @dev is expected to be DMA-capable then the bus code that created
- * it should have initialised its dma_mask pointer by this point. For
- * now, we'll continue the legacy behaviour of coercing it to the
- * coherent mask if not, but we'll no longer do so quietly.
- */
- if (!dev->dma_mask) {
- dev_warn(dev, "DMA mask not set\n");
- dev->dma_mask = &dev->coherent_dma_mask;
- }
-
- if (dev->coherent_dma_mask)
- size = max(dev->coherent_dma_mask, dev->coherent_dma_mask + 1);
+ if (dev_is_pci(dev))
+ return rc_dma_get_range(dev, size);
else
- size = 1ULL << 32;
-
- ret = acpi_dma_get_range(dev, &dmaaddr, &offset, &size);
- if (ret == -ENODEV)
- ret = dev_is_pci(dev) ? rc_dma_get_range(dev, &size)
- : nc_dma_get_range(dev, &size);
-
- if (!ret) {
- /*
- * Limit coherent and dma mask based on size retrieved from
- * firmware.
- */
- end = dmaaddr + size - 1;
- mask = DMA_BIT_MASK(ilog2(end) + 1);
- dev->bus_dma_limit = end;
- dev->coherent_dma_mask = min(dev->coherent_dma_mask, mask);
- *dev->dma_mask = min(*dev->dma_mask, mask);
- }
-
- *dma_addr = dmaaddr;
- *dma_size = size;
-
- ret = dma_direct_set_offset(dev, dmaaddr + offset, dmaaddr, size);
-
- dev_dbg(dev, "dma_offset(%#08llx)%s\n", offset, ret ? " failed!" : "");
+ return nc_dma_get_range(dev, size);
}
static void __init acpi_iort_register_irq(int hwirq, const char *name,
@@ -1537,7 +1537,7 @@ int acpi_dma_configure_id(struct device *dev, enum dev_dma_attr attr,
return 0;
}
- iort_dma_setup(dev, &dma_addr, &size);
+ acpi_arch_dma_setup(dev, &dma_addr, &size);
iommu = iort_iommu_configure_id(dev, input_id);
if (PTR_ERR(iommu) == -EPROBE_DEFER)
Extract generic DMA setup code out of IORT, so it can be reused by VIOT. Keep it in drivers/acpi/arm64 for now, since it could break x86 platforms that haven't run this code so far, if they have invalid tables. Signed-off-by: Jean-Philippe Brucker <jean-philippe@linaro.org> --- drivers/acpi/arm64/Makefile | 1 + include/linux/acpi.h | 3 +++ include/linux/acpi_iort.h | 6 ++--- drivers/acpi/arm64/dma.c | 50 ++++++++++++++++++++++++++++++++++ drivers/acpi/arm64/iort.c | 54 ++++++------------------------------- drivers/acpi/scan.c | 2 +- 6 files changed, 66 insertions(+), 50 deletions(-) create mode 100644 drivers/acpi/arm64/dma.c