| Message ID | 20210624224909.6350-3-pali@kernel.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | serial: mvebu-uart: Fixes and new support for higher baudrates | expand |
diff --git a/drivers/tty/serial/mvebu-uart.c b/drivers/tty/serial/mvebu-uart.c index f81bfdaa608c..dc0c26824ddb 100644 --- a/drivers/tty/serial/mvebu-uart.c +++ b/drivers/tty/serial/mvebu-uart.c @@ -445,12 +445,11 @@ static void mvebu_uart_shutdown(struct uart_port *port) static int mvebu_uart_baud_rate_set(struct uart_port *port, unsigned int baud) { - struct mvebu_uart *mvuart = to_mvuart(port); unsigned int d_divisor, m_divisor; u32 brdv, osamp; - if (IS_ERR(mvuart->clk)) - return -PTR_ERR(mvuart->clk); + if (!port->uartclk) + return -EOPNOTSUPP; /* * The baudrate is derived from the UART clock thanks to two divisors:
Testing mvuart->clk for non-error is not enough as mvuart->clk may contain valid clk pointer but when clk_prepare_enable(mvuart->clk) failed then port->uartclk is zero. When mvuart->clk is not available then port->uartclk is zero too. Parent clock rate port->uartclk is needed to calculate UART clock divisor and without it is not possible to change baudrate. So fix test condition when it is possible to change baudrate. Signed-off-by: Pali Rohár <pali@kernel.org> Fixes: 68a0db1d7da2 ("serial: mvebu-uart: add function to change baudrate") --- drivers/tty/serial/mvebu-uart.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)