| Message ID | 20220113091056.1297982-7-james.clark@arm.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | coresight: Add config flag to enable branch broadcast | expand |
On Thu, 13 Jan 2022 at 09:11, James Clark <james.clark@arm.com> wrote: > > Now that there is a way of enabling branch broadcast via perf, mention > the possible use cases and known limitations. > > Signed-off-by: James Clark <james.clark@arm.com> > --- > .../trace/coresight/coresight-etm4x-reference.rst | 10 +++++++++- > 1 file changed, 9 insertions(+), 1 deletion(-) > > diff --git a/Documentation/trace/coresight/coresight-etm4x-reference.rst b/Documentation/trace/coresight/coresight-etm4x-reference.rst > index 0439b4006227..ec336575919c 100644 > --- a/Documentation/trace/coresight/coresight-etm4x-reference.rst > +++ b/Documentation/trace/coresight/coresight-etm4x-reference.rst > @@ -656,7 +656,15 @@ Bit assignments shown below:- > ETM_MODE_BB > > **description:** > - Set to enable branch broadcast if supported in hardware [IDR0]. > + Set to enable branch broadcast if supported in hardware [IDR0]. The primary use for this feature > + is when code is patched dynamically at run time and the full program flow may not be able to be > + reconstructed using only conditional branches. > + > + Choosing this option will result in a significant increase in the amount of trace generated - > + possible danger of overflows, or fewer instructions covered. Note, that this option also > + overrides any setting of :ref:`ETM_MODE_RETURNSTACK <coresight-return-stack>`, so where a branch > + broadcast range overlaps a return stack range, return stacks will not be available for that > + range. > > .. _coresight-cycle-accurate: > > -- > 2.28.0 > Reviewed-by: Mike Leach <mike.leach@linaro.org>
diff --git a/Documentation/trace/coresight/coresight-etm4x-reference.rst b/Documentation/trace/coresight/coresight-etm4x-reference.rst index 0439b4006227..ec336575919c 100644 --- a/Documentation/trace/coresight/coresight-etm4x-reference.rst +++ b/Documentation/trace/coresight/coresight-etm4x-reference.rst @@ -656,7 +656,15 @@ Bit assignments shown below:- ETM_MODE_BB **description:** - Set to enable branch broadcast if supported in hardware [IDR0]. + Set to enable branch broadcast if supported in hardware [IDR0]. The primary use for this feature + is when code is patched dynamically at run time and the full program flow may not be able to be + reconstructed using only conditional branches. + + Choosing this option will result in a significant increase in the amount of trace generated - + possible danger of overflows, or fewer instructions covered. Note, that this option also + overrides any setting of :ref:`ETM_MODE_RETURNSTACK <coresight-return-stack>`, so where a branch + broadcast range overlaps a return stack range, return stacks will not be available for that + range. .. _coresight-cycle-accurate:
Now that there is a way of enabling branch broadcast via perf, mention the possible use cases and known limitations. Signed-off-by: James Clark <james.clark@arm.com> --- .../trace/coresight/coresight-etm4x-reference.rst | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)