deleted file mode 100644
@@ -1,63 +0,0 @@
-* Qualcomm Technologies Inc Universal Flash Storage (UFS) PHY
-
-UFSPHY nodes are defined to describe on-chip UFS PHY hardware macro.
-Each UFS PHY node should have its own node.
-
-To bind UFS PHY with UFS host controller, the controller node should
-contain a phandle reference to UFS PHY node.
-
-Required properties:
-- compatible : compatible list, contains one of the following -
- "qcom,ufs-phy-qmp-20nm" for 20nm ufs phy,
- "qcom,ufs-phy-qmp-14nm" for legacy 14nm ufs phy,
- "qcom,msm8996-ufs-phy-qmp-14nm" for 14nm ufs phy
- present on MSM8996 chipset.
-- reg : should contain PHY register address space (mandatory),
-- reg-names : indicates various resources passed to driver (via reg proptery) by name.
- Required "reg-names" is "phy_mem".
-- #phy-cells : This property shall be set to 0
-- vdda-phy-supply : phandle to main PHY supply for analog domain
-- vdda-pll-supply : phandle to PHY PLL and Power-Gen block power supply
-- clocks : List of phandle and clock specifier pairs
-- clock-names : List of clock input name strings sorted in the same
- order as the clocks property. "ref_clk_src", "ref_clk",
- "tx_iface_clk" & "rx_iface_clk" are mandatory but
- "ref_clk_parent" is optional
-
-Optional properties:
-- vdda-phy-max-microamp : specifies max. load that can be drawn from phy supply
-- vdda-pll-max-microamp : specifies max. load that can be drawn from pll supply
-- vddp-ref-clk-supply : phandle to UFS device ref_clk pad power supply
-- vddp-ref-clk-max-microamp : specifies max. load that can be drawn from this supply
-- resets : specifies the PHY reset in the UFS controller
-
-Example:
-
- ufsphy1: ufsphy@fc597000 {
- compatible = "qcom,ufs-phy-qmp-20nm";
- reg = <0xfc597000 0x800>;
- reg-names = "phy_mem";
- #phy-cells = <0>;
- vdda-phy-supply = <&pma8084_l4>;
- vdda-pll-supply = <&pma8084_l12>;
- vdda-phy-max-microamp = <50000>;
- vdda-pll-max-microamp = <1000>;
- clock-names = "ref_clk_src",
- "ref_clk_parent",
- "ref_clk",
- "tx_iface_clk",
- "rx_iface_clk";
- clocks = <&clock_rpm clk_ln_bb_clk>,
- <&clock_gcc clk_pcie_1_phy_ldo >,
- <&clock_gcc clk_ufs_phy_ldo>,
- <&clock_gcc clk_gcc_ufs_tx_cfg_clk>,
- <&clock_gcc clk_gcc_ufs_rx_cfg_clk>;
- resets = <&ufshc 0>;
- };
-
- ufshc: ufshc@fc598000 {
- #reset-cells = <1>;
- ...
- phys = <&ufsphy1>;
- phy-names = "ufsphy";
- };