diff mbox series

[v6,1/5] drm/bridge: nwl-dsi: Set PHY mode in nwl_dsi_mode_set()

Message ID 20220402040325.2465222-2-victor.liu@nxp.com (mailing list archive)
State New, archived
Headers show
Series phy: phy-fsl-imx8-mipi-dphy: Add i.MX8qxp LVDS PHY mode support | expand

Commit Message

Liu Ying April 2, 2022, 4:03 a.m. UTC
The Northwest Logic MIPI DSI host controller embedded in i.MX8qxp
works with a Mixel MIPI DPHY + LVDS PHY combo to support either
a MIPI DSI display or a LVDS display.  So, this patch calls
phy_set_mode() from nwl_dsi_mode_set() to set PHY mode to MIPI DPHY
explicitly.

Cc: Guido Günther <agx@sigxcpu.org>
Cc: Robert Chiras <robert.chiras@nxp.com>
Cc: Martin Kepplinger <martin.kepplinger@puri.sm>
Cc: Andrzej Hajda <a.hajda@samsung.com>
Cc: Neil Armstrong <narmstrong@baylibre.com>
Cc: Laurent Pinchart <Laurent.pinchart@ideasonboard.com>
Cc: Jonas Karlman <jonas@kwiboo.se>
Cc: Jernej Skrabec <jernej.skrabec@siol.net>
Cc: David Airlie <airlied@linux.ie>
Cc: Daniel Vetter <daniel@ffwll.ch>
Cc: NXP Linux Team <linux-imx@nxp.com>
Signed-off-by: Liu Ying <victor.liu@nxp.com>
---
v5->v6:
* Rebase the series upon v5.17-rc1.
* Set PHY mode in ->mode_set() instead of ->pre_enable() in the nwl-dsi
  bridge driver due to the rebase.
* Drop Guido's R-b tag due to the rebase.

v4->v5:
* No change.

v3->v4:
* No change.

v2->v3:
* No change.

v1->v2:
* Add Guido's R-b tag.

 drivers/gpu/drm/bridge/nwl-dsi.c | 6 ++++++
 1 file changed, 6 insertions(+)
diff mbox series

Patch

diff --git a/drivers/gpu/drm/bridge/nwl-dsi.c b/drivers/gpu/drm/bridge/nwl-dsi.c
index af07eeb47ca0..cbe3edb17ceb 100644
--- a/drivers/gpu/drm/bridge/nwl-dsi.c
+++ b/drivers/gpu/drm/bridge/nwl-dsi.c
@@ -671,6 +671,12 @@  static int nwl_dsi_mode_set(struct nwl_dsi *dsi)
 		return ret;
 	}
 
+	ret = phy_set_mode(dsi->phy, PHY_MODE_MIPI_DPHY);
+	if (ret < 0) {
+		DRM_DEV_ERROR(dev, "Failed to set DSI phy mode: %d\n", ret);
+		goto uninit_phy;
+	}
+
 	ret = phy_configure(dsi->phy, phy_cfg);
 	if (ret < 0) {
 		DRM_DEV_ERROR(dev, "Failed to configure DSI phy: %d\n", ret);