diff mbox series

[v1,15/17] ARM: dts: imx6q-apalis: backlight pwm: Simplify inverted backlight

Message ID 20220516115846.58328-16-max.oss.09@gmail.com (mailing list archive)
State New, archived
Headers show
Series ARM: dts: imx6q-apalis: Misc improvements and newly added carrier | expand

Commit Message

Max Krummenacher May 16, 2022, 11:58 a.m. UTC
From: Max Krummenacher <max.krummenacher@toradex.com>

Set #pwm-cells to the default 3 to gain access to the parameter
which allows inverting the PWM signal. This is useful to specify
a backlight which has its highest brightness at 0.

With the change to use the PWM with inverted polarity the PWM signal
is inverted to how it was before this patch.
This changes the meaning of the values in the brightness-levels
property. I.e. the duty-cycle changes from x/255 to (255-x)/255.
Keeping the brightness-levels will then have a big brightness
jump from 0 to 127 duty cycle, the other 6 steps will then be
barely noticeable.

Change the brightness-levels to provide the same brightness-levels
as before.

Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
---

 arch/arm/boot/dts/imx6qdl-apalis.dtsi | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
index 57642aefe349..49669caac8b7 100644
--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -6,6 +6,7 @@ 
  */
 
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/pwm/pwm.h>
 
 / {
 	model = "Toradex Apalis iMX6Q/D Module";
@@ -19,13 +20,13 @@ 
 
 	backlight: backlight {
 		compatible = "pwm-backlight";
+		brightness-levels = <0 4 8 16 32 64 128 255>;
+		default-brightness-level = <6>;
+		enable-gpios = <&gpio3 13 GPIO_ACTIVE_HIGH>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_gpio_bl_on>;
-		brightness-levels = <0 127 191 223 239 247 251 255>;
-		default-brightness-level = <1>;
-		enable-gpios = <&gpio3 13 GPIO_ACTIVE_HIGH>;
 		power-supply = <&reg_module_3v3>;
-		pwms = <&pwm4 0 5000000>;
+		pwms = <&pwm4 0 5000000 PWM_POLARITY_INVERTED>;
 		status = "disabled";
 	};
 
@@ -761,7 +762,6 @@ 
 };
 
 &pwm4 {
-	#pwm-cells = <2>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_pwm4>;
 	status = "disabled";