diff mbox series

[v1,04/17] ARM: dts: imx6q-apalis: Command pmic to standby for poweroff

Message ID 20220516115846.58328-5-max.oss.09@gmail.com (mailing list archive)
State New, archived
Headers show
Series ARM: dts: imx6q-apalis: Misc improvements and newly added carrier | expand

Commit Message

Max Krummenacher May 16, 2022, 11:58 a.m. UTC
From: Max Krummenacher <max.krummenacher@toradex.com>

The Apalis iMX6 HW doesn't allow to use the PWR_ON_REQ signal for
poweroff. Use the fsl,pmic-stby-poweroff property to command the PMIC
into a low power mode in poweroff.

Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
---

 arch/arm/boot/dts/imx6qdl-apalis.dtsi | 5 +++++
 1 file changed, 5 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
index e56451651a6d..668793356b46 100644
--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -125,6 +125,10 @@ 
 	status = "disabled";
 };
 
+&clks {
+	fsl,pmic-stby-poweroff;
+};
+
 /* Apalis SPI1 */
 &ecspi1 {
 	cs-gpios = <&gpio5 25 GPIO_ACTIVE_LOW>;
@@ -387,6 +391,7 @@ 
 
 	pmic: pfuze100@8 {
 		compatible = "fsl,pfuze100";
+		fsl,pmic-stby-poweroff;
 		reg = <0x08>;
 
 		regulators {