@@ -507,6 +507,11 @@ struct kvm_vcpu_arch {
/* Save TRBE context if active */
#define DEBUG_STATE_SAVE_TRBE __vcpu_single_flag(iflags, BIT(6))
+/* SVE enabled for host EL0 */
+#define HOST_SVE_ENABLED __vcpu_single_flag(sflags, BIT(0))
+/* SME enabled for EL0 */
+#define HOST_SME_ENABLED __vcpu_single_flag(sflags, BIT(1))
+
/* Pointer to the vcpu's SVE FFR for sve_{save,load}_state() */
#define vcpu_sve_pffr(vcpu) (kern_hyp_va((vcpu)->arch.sve_state) + \
sve_ffr_offset((vcpu)->arch.sve_max_vl))
@@ -528,11 +533,8 @@ struct kvm_vcpu_arch {
})
/* vcpu_arch flags field values: */
-#define KVM_ARM64_HOST_SVE_ENABLED (1 << 4) /* SVE enabled for EL0 */
#define KVM_ARM64_ON_UNSUPPORTED_CPU (1 << 15) /* Physical CPU not in supported_cpus */
-#define KVM_ARM64_HOST_SME_ENABLED (1 << 16) /* SME enabled for EL0 */
#define KVM_ARM64_WFIT (1 << 17) /* WFIT instruction trapped */
-
#define KVM_GUESTDBG_VALID_MASK (KVM_GUESTDBG_ENABLE | \
KVM_GUESTDBG_USE_SW_BP | \
KVM_GUESTDBG_USE_HW | \
@@ -79,9 +79,9 @@ void kvm_arch_vcpu_load_fp(struct kvm_vcpu *vcpu)
vcpu->arch.fp_state = FP_STATE_DIRTY_HOST;
- vcpu->arch.flags &= ~KVM_ARM64_HOST_SVE_ENABLED;
+ vcpu_clear_flag(vcpu, HOST_SVE_ENABLED);
if (read_sysreg(cpacr_el1) & CPACR_EL1_ZEN_EL0EN)
- vcpu->arch.flags |= KVM_ARM64_HOST_SVE_ENABLED;
+ vcpu_set_flag(vcpu, HOST_SVE_ENABLED);
/*
* We don't currently support SME guests but if we leave
@@ -93,9 +93,9 @@ void kvm_arch_vcpu_load_fp(struct kvm_vcpu *vcpu)
* operations. Do this for ZA as well for now for simplicity.
*/
if (system_supports_sme()) {
- vcpu->arch.flags &= ~KVM_ARM64_HOST_SME_ENABLED;
+ vcpu_clear_flag(vcpu, HOST_SME_ENABLED);
if (read_sysreg(cpacr_el1) & CPACR_EL1_SMEN_EL0EN)
- vcpu->arch.flags |= KVM_ARM64_HOST_SME_ENABLED;
+ vcpu_set_flag(vcpu, HOST_SME_ENABLED);
if (read_sysreg_s(SYS_SVCR_EL0) &
(SYS_SVCR_EL0_SM_MASK | SYS_SVCR_EL0_ZA_MASK)) {
@@ -165,7 +165,7 @@ void kvm_arch_vcpu_put_fp(struct kvm_vcpu *vcpu)
*/
if (has_vhe() && system_supports_sme()) {
/* Also restore EL0 state seen on entry */
- if (vcpu->arch.flags & KVM_ARM64_HOST_SME_ENABLED)
+ if (vcpu_get_flag(vcpu, HOST_SME_ENABLED))
sysreg_clear_set(CPACR_EL1, 0,
CPACR_EL1_SMEN_EL0EN |
CPACR_EL1_SMEN_EL1EN);
@@ -194,7 +194,7 @@ void kvm_arch_vcpu_put_fp(struct kvm_vcpu *vcpu)
* for EL0. To avoid spurious traps, restore the trap state
* seen by kvm_arch_vcpu_load_fp():
*/
- if (vcpu->arch.flags & KVM_ARM64_HOST_SVE_ENABLED)
+ if (vcpu_get_flag(vcpu, HOST_SVE_ENABLED))
sysreg_clear_set(CPACR_EL1, 0, CPACR_EL1_ZEN_EL0EN);
else
sysreg_clear_set(CPACR_EL1, CPACR_EL1_ZEN_EL0EN, 0);
The two HOST_{SVE,SME}_ENABLED are only used for the host kernel to track its own state across a vcpu run so that it can be fully restored. Move these flags to the so called state set. Signed-off-by: Marc Zyngier <maz@kernel.org> --- arch/arm64/include/asm/kvm_host.h | 8 +++++--- arch/arm64/kvm/fpsimd.c | 12 ++++++------ 2 files changed, 11 insertions(+), 9 deletions(-)