@@ -2630,10 +2630,6 @@ static int __init atmel_console_setup(struct console *co, char *options)
return -ENODEV;
}
- ret = clk_prepare_enable(atmel_ports[co->index].clk);
- if (ret)
- return ret;
-
atmel_uart_writel(port, ATMEL_US_IDR, -1);
atmel_uart_writel(port, ATMEL_US_CR, ATMEL_US_RSTSTA | ATMEL_US_RSTRX);
atmel_uart_writel(port, ATMEL_US_CR, ATMEL_US_TXEN | ATMEL_US_RXEN);
@@ -2914,17 +2910,6 @@ static int atmel_serial_probe(struct platform_device *pdev)
if (ret)
goto err_add_port;
-#ifdef CONFIG_SERIAL_ATMEL_CONSOLE
- if (uart_console(&atmel_port->uart)
- && ATMEL_CONSOLE_DEVICE->flags & CON_ENABLED) {
- /*
- * The serial core enabled the clock for us, so undo
- * the clk_prepare_enable() in atmel_console_setup()
- */
- clk_disable_unprepare(atmel_port->clk);
- }
-#endif
-
device_init_wakeup(&pdev->dev, 1);
platform_set_drvdata(pdev, atmel_port);
There is no need for clk_prepare_enable() at the beginning of atmel_console_setup() and clk_disable_unprepare() at the end of atmel_console_setup() as the clock is already enabled when calling atmel_console_setup() and its disablement is done at the end of probe. Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com> --- drivers/tty/serial/atmel_serial.c | 15 --------------- 1 file changed, 15 deletions(-)