| Message ID | 20220830182821.47919-1-andriy.shevchenko@linux.intel.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | [v1,1/2] spi: stm32-qspi: Replace of_gpio_named_count() by gpiod_count() | expand |
Hi Andy On 8/30/22 20:28, Andy Shevchenko wrote: > As a preparation to unexport of_gpio_named_count(), convert the > driver to use gpiod_count() instead. > > Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> > --- > drivers/spi/spi-stm32-qspi.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c > index 227f450aa5f0..5858f5f9c758 100644 > --- a/drivers/spi/spi-stm32-qspi.c > +++ b/drivers/spi/spi-stm32-qspi.c > @@ -656,7 +656,7 @@ static int stm32_qspi_setup(struct spi_device *spi) > mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL); > if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) || > ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && > - of_gpio_named_count(qspi->dev->of_node, "cs-gpios") == -ENOENT)) { > + gpiod_count(qspi->dev, "cs") == -ENOENT)) { > dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n"); > dev_err(qspi->dev, "configuration not supported\n"); > > @@ -681,7 +681,7 @@ static int stm32_qspi_setup(struct spi_device *spi) > * are both set in spi->mode and "cs-gpios" properties is found in DT > */ > if (((spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL)) == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && > - of_gpio_named_count(qspi->dev->of_node, "cs-gpios")) { > + gpiod_count(qspi->dev, "cs")) { > qspi->cr_reg |= CR_DFM; > dev_dbg(qspi->dev, "Dual flash mode enable"); > } Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com> Thanks Patrice
On Tue, 30 Aug 2022 21:28:20 +0300, Andy Shevchenko wrote: > As a preparation to unexport of_gpio_named_count(), convert the > driver to use gpiod_count() instead. > > Applied to https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-next Thanks! [1/2] spi: stm32-qspi: Replace of_gpio_named_count() by gpiod_count() commit: eea0e7d20d6dab38522ac0a3af61fd92c53c34f6 [2/2] spi: stm32-qspi: Refactor dual flash mode enable check in ->setup() commit: c9448aa41ac7dd223a6bef79e71d6c168593ebb7 All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted. You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed. If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced. Please add any relevant lists and maintainers to the CCs when replying to this mail. Thanks, Mark
diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c index 227f450aa5f0..5858f5f9c758 100644 --- a/drivers/spi/spi-stm32-qspi.c +++ b/drivers/spi/spi-stm32-qspi.c @@ -656,7 +656,7 @@ static int stm32_qspi_setup(struct spi_device *spi) mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL); if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) || ((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && - of_gpio_named_count(qspi->dev->of_node, "cs-gpios") == -ENOENT)) { + gpiod_count(qspi->dev, "cs") == -ENOENT)) { dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n"); dev_err(qspi->dev, "configuration not supported\n"); @@ -681,7 +681,7 @@ static int stm32_qspi_setup(struct spi_device *spi) * are both set in spi->mode and "cs-gpios" properties is found in DT */ if (((spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL)) == (SPI_TX_OCTAL | SPI_RX_OCTAL)) && - of_gpio_named_count(qspi->dev->of_node, "cs-gpios")) { + gpiod_count(qspi->dev, "cs")) { qspi->cr_reg |= CR_DFM; dev_dbg(qspi->dev, "Dual flash mode enable"); }
As a preparation to unexport of_gpio_named_count(), convert the driver to use gpiod_count() instead. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/spi/spi-stm32-qspi.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)