@@ -30,6 +30,12 @@ vcc_5v: vcc-5v-regulator {
};
};
+/* phy for pcie */
+&combphy2 {
+ phy-supply = <&vcc3v3_sys>;
+ status = "okay";
+};
+
&gmac1 {
status = "okay";
};
@@ -105,6 +111,11 @@ &led_work {
status = "okay";
};
+&pcie2x1 {
+ vpcie3v3-supply = <&vcc_3v3>;
+ status = "okay";
+};
+
&rgmii_phy1 {
status = "okay";
};
@@ -487,6 +487,12 @@ rgmii_phy1: ethernet-phy@0 {
};
};
+&pcie2x1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pcie_reset_h>;
+ reset-gpios = <&gpio1 RK_PB2 GPIO_ACTIVE_HIGH>;
+};
+
&pinctrl {
bt {
bt_enable_h: bt-enable-h {
@@ -512,6 +518,15 @@ diy_led_enable_h: diy-led-enable-h {
};
};
+ pcie {
+ pcie_clkreq_h: pcie-clkreq-h {
+ rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ pcie_reset_h: pcie-reset-h {
+ rockchip,pins = <1 RK_PB2 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
pmic {
pmic_int_l: pmic-int-l {
rockchip,pins = <0 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>;
This patch enables the PCIe2 on the CM4IO board when paired with a SOQuartz CM4 System-on-Module board. combphy2 also needs to be enabled in this case to make the PHY work for this. Signed-off-by: Nicolas Frattaroli <frattaroli.nicolas@gmail.com> --- .../boot/dts/rockchip/rk3566-soquartz-cm4.dts | 11 +++++++++++ arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi | 15 +++++++++++++++ 2 files changed, 26 insertions(+)