[v3,7/9] arm64: dts: amlogic: Used onboard usb hub reset on odroid c4

Commit Message

Anand Moon Jan. 21, 2023, 5:56 p.m. UTC

On Odroid c4 previously use gpio-hog to reset the usb hub,
switch to used on-board usb hub reset to enable the usb hub
and enable power to hub.

USB hub is combination of USB 2.0 and USB 3.0 root hub so
use peer-hub node to link then.

Signed-off-by: Anand Moon <[e-mail]>
---
v3: - move the usb hub under dwc3 node.
      dropped dr_mode
v2: - fix the compatible string.
    - Fix the hub node to use peer-hub to link the usb 2.0 and usb 3.0.
---
 .../boot/dts/amlogic/meson-sm1-odroid-c4.dts  | 33 ++++++++++++-------
 1 file changed, 21 insertions(+), 12 deletions(-)

Patch

diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
index 8c30ce63686e..a988015dd2d5 100644
--- a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
@@ -28,18 +28,27 @@  sound {
 	};
 };
 
-&gpio {
-	/*
-	 * WARNING: The USB Hub on the Odroid-C4 needs a reset signal
-	 * to be turned high in order to be detected by the USB Controller
-	 * This signal should be handled by a USB specific power sequence
-	 * in order to reset the Hub when USB bus is powered down.
-	 */
-	hog-0 {
-		gpio-hog;
-		gpios = <GPIOH_4 GPIO_ACTIVE_HIGH>;
-		output-high;
-		line-name = "usb-hub-reset";
+&dwc3 {
+	/* USB hub supports both USB 2.0 and USB 3.0 root hub */
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	/* 2.0 hub on port 1 */
+	hub_2_0: hub@1 {
+		compatible = "usb2109,2817";
+		reg = <1>;
+		peer-hub = <&hub_3_0>;
+		reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
+		vdd-supply = <&vcc_5v>;
+	};
+
+	/* 3.1 hub on port 4 */
+	hub_3_0: hub@2 {
+		compatible = "usb2109,817";
+		reg = <2>;
+		peer-hub = <&hub_2_0>;
+		reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
+		vdd-supply = <&vcc_5v>;
 	};
 };