@@ -22,7 +22,7 @@ memory@70000000 {
};
display-0 {
- #address-cells =<1>;
+ #address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,imx-parallel-display";
interface-pix-fmt = "rgb24";
@@ -22,7 +22,7 @@ touchscreen@41 {
compatible = "ilitek,ili251x";
reg = <0x41>;
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_q7_gpio0>;
+ pinctrl-0 = <&pinctrl_q7_gpio0>;
interrupt-parent = <&gpio5>;
interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
reset-gpios = <&tca6424a 21 GPIO_ACTIVE_LOW>;
@@ -22,7 +22,7 @@ touchscreen@41 {
compatible = "ilitek,ili251x";
reg = <0x41>;
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_q7_gpio0>;
+ pinctrl-0 = <&pinctrl_q7_gpio0>;
interrupt-parent = <&gpio5>;
interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
reset-gpios = <&tca6424a 21 GPIO_ACTIVE_LOW>;
@@ -22,7 +22,7 @@ touchscreen@2a {
compatible = "eeti,exc80h60";
reg = <0x2a>;
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_q7_gpio0>;
+ pinctrl-0 = <&pinctrl_q7_gpio0>;
interrupt-parent = <&gpio5>;
interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&tca6424a 21 GPIO_ACTIVE_HIGH>;
@@ -22,7 +22,7 @@ touchscreen@2a {
compatible = "eeti,exc80h60";
reg = <0x2a>;
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_q7_gpio0>;
+ pinctrl-0 = <&pinctrl_q7_gpio0>;
interrupt-parent = <&gpio5>;
interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&tca6424a 21 GPIO_ACTIVE_HIGH>;
@@ -22,7 +22,7 @@ touchscreen@2a {
compatible = "eeti,exc80h84";
reg = <0x2a>;
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_q7_gpio0>;
+ pinctrl-0 = <&pinctrl_q7_gpio0>;
interrupt-parent = <&gpio5>;
interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
touchscreen-inverted-x;
@@ -16,7 +16,7 @@ / {
compatible = "variscite,mx6customboard", "variscite,var-som-imx6q", "fsl,imx6q";
panel0: lvds-panel0 {
- compatible = "panel-lvds";
+ compatible = "panel-lvds";
backlight = <&backlight_lvds>;
width-mm = <152>;
height-mm = <91>;
@@ -43,7 +43,7 @@ panel_in_lvds0: endpoint {
};
panel1: lvds-panel1 {
- compatible = "panel-lvds";
+ compatible = "panel-lvds";
width-mm = <152>;
height-mm = <91>;
data-mapping = "jeida-18";
@@ -166,7 +166,7 @@ reg_usb_host_vbus_hub: regulator-usb-host-vbus-hub {
reg_usb_host_vbus: regulator-usb-host-vbus {
compatible = "regulator-fixed";
enable-active-high;
- gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>;
+ gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_regulator_usbh_pwr>;
regulator-max-microvolt = <5000000>;
@@ -54,7 +54,7 @@ reg_usb_otg: reg-otgvbus {
clk_codec: clock-codec {
compatible = "fixed-clock";
#clock-cells = <0>;
- clock-frequency = <12000000>;
+ clock-frequency = <12000000>;
};
sound {
@@ -25,7 +25,7 @@ adc_ts: adc@0 {
compatible = "ti,tsc2046e-adc";
reg = <0>;
pinctrl-0 = <&pinctrl_touch>;
- pinctrl-names ="default";
+ pinctrl-names = "default";
spi-max-frequency = <1000000>;
interrupts-extended = <&gpio3 19 IRQ_TYPE_LEVEL_LOW>;
#io-channel-cells = <1>;
@@ -475,7 +475,7 @@ asrc: asrc@2034000 {
<&sdma 20 23 1>, <&sdma 21 23 1>, <&sdma 22 23 1>;
dma-names = "rxa", "rxb", "rxc",
"txa", "txb", "txc";
- fsl,asrc-rate = <48000>;
+ fsl,asrc-rate = <48000>;
fsl,asrc-width = <16>;
status = "okay";
};
@@ -418,7 +418,7 @@ asrc: asrc@2034000 {
<&sdma 21 23 1>, <&sdma 22 23 1>;
dma-names = "rxa", "rxb", "rxc",
"txa", "txb", "txc";
- fsl,asrc-rate = <48000>;
+ fsl,asrc-rate = <48000>;
fsl,asrc-width = <16>;
status = "okay";
};
@@ -1010,7 +1010,7 @@ usdhc1: mmc@2190000 {
clock-names = "ipg", "ahb", "per";
bus-width = <4>;
fsl,tuning-start-tap = <20>;
- fsl,tuning-step= <2>;
+ fsl,tuning-step = <2>;
status = "disabled";
};
@@ -1024,7 +1024,7 @@ usdhc2: mmc@2194000 {
clock-names = "ipg", "ahb", "per";
bus-width = <4>;
fsl,tuning-start-tap = <20>;
- fsl,tuning-step= <2>;
+ fsl,tuning-step = <2>;
status = "disabled";
};
@@ -1038,7 +1038,7 @@ usdhc3: mmc@2198000 {
clock-names = "ipg", "ahb", "per";
bus-width = <4>;
fsl,tuning-start-tap = <20>;
- fsl,tuning-step= <2>;
+ fsl,tuning-step = <2>;
status = "disabled";
};
@@ -364,7 +364,7 @@ asrc: asrc@2034000 {
<&sdma 20 23 1>, <&sdma 21 23 1>, <&sdma 22 23 1>;
dma-names = "rxa", "rxb", "rxc",
"txa", "txb", "txc";
- fsl,asrc-rate = <48000>;
+ fsl,asrc-rate = <48000>;
fsl,asrc-width = <16>;
status = "okay";
};
@@ -212,7 +212,7 @@ &usdhc3 {
keep-power-in-suspend;
wakeup-source;
vmmc-supply = <®_wlreg_on>;
- vqmmc-supply =<®_3p3v>;
+ vqmmc-supply = <®_3p3v>;
status = "okay";
brcmf: wifi@1 {
@@ -149,7 +149,7 @@ &fec2 {
&i2c2 {
pinctrl-names = "default";
- pinctrl-0 =<&pinctrl_i2c2>;
+ pinctrl-0 = <&pinctrl_i2c2>;
clock-frequency = <100000>;
status = "okay";
@@ -74,7 +74,7 @@ soc {
sct_pwm: pwm@40000000 {
compatible = "nxp,lpc1850-sct-pwm";
reg = <0x40000000 0x1000>;
- clocks =<&ccu1 CLK_CPU_SCT>;
+ clocks = <&ccu1 CLK_CPU_SCT>;
clock-names = "pwm";
resets = <&rgu 37>;
#pwm-cells = <3>;
@@ -112,7 +112,7 @@ msi1: msi-controller@1570e00 {
compatible = "fsl,ls1021a-msi";
reg = <0x0 0x1570e00 0x0 0x8>;
msi-controller;
- interrupts = <GIC_SPI 179 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <GIC_SPI 179 IRQ_TYPE_LEVEL_HIGH>;
};
msi2: msi-controller@1570e08 {
@@ -55,7 +55,7 @@ &bl {
brightness-levels = <0 4 8 16 32 64 128 255>;
default-brightness-level = <6>;
power-supply = <®_3v3>;
- status = "okay";
+ status = "okay";
};
&dcu0 {
@@ -68,7 +68,7 @@ spi {
#address-cells = <1>;
#size-cells = <0>;
/* PTD12 ->RPIO[91] */
- sck-gpios = <&gpio2 27 GPIO_ACTIVE_LOW>;
+ sck-gpios = <&gpio2 27 GPIO_ACTIVE_LOW>;
/* PTD10 ->RPIO[89] */
miso-gpios = <&gpio2 25 GPIO_ACTIVE_HIGH>;
num-chipselects = <0>;
@@ -79,7 +79,7 @@ gpio@0 {
gpio-controller;
#gpio-cells = <2>;
/* PTB18 -> RGPIO[40] */
- load-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
+ load-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
spi-max-frequency = <100000>;
};
};
@@ -294,11 +294,11 @@ spi-0 {
pinctrl-names = "default";
#address-cells = <1>;
#size-cells = <0>;
- sck-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
+ sck-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
mosi-gpios = <&gpio1 11 GPIO_ACTIVE_HIGH>;
miso-gpios = <&gpio1 10 GPIO_ACTIVE_HIGH>;
- cs-gpios = <&gpio1 9 GPIO_ACTIVE_LOW
- &gpio1 8 GPIO_ACTIVE_HIGH>;
+ cs-gpios = <&gpio1 9 GPIO_ACTIVE_LOW
+ &gpio1 8 GPIO_ACTIVE_HIGH>;
num-chipselects = <2>;
flash@0 {
The DTS code coding style expects exactly one space before and after '=' sign. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- arch/arm/boot/dts/nxp/imx/imx53-cx9020.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6dl-b105pv2.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6dl-b105v2.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6dl-b125pv2.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6dl-b125v2.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6dl-b155v2.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx6q-var-mx6customboard.dts | 4 ++-- arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi | 2 +- arch/arm/boot/dts/nxp/imx/imx6qdl-emcon-avari.dtsi | 2 +- arch/arm/boot/dts/nxp/imx/imx6qdl-skov-cpu-revc.dtsi | 2 +- arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi | 2 +- arch/arm/boot/dts/nxp/imx/imx6sx.dtsi | 8 ++++---- arch/arm/boot/dts/nxp/imx/imx6ul.dtsi | 2 +- arch/arm/boot/dts/nxp/imx/imx7d-meerkat96.dts | 2 +- arch/arm/boot/dts/nxp/imx/imx7d-smegw01.dts | 2 +- arch/arm/boot/dts/nxp/lpc/lpc18xx.dtsi | 2 +- arch/arm/boot/dts/nxp/ls/ls1021a.dtsi | 2 +- arch/arm/boot/dts/nxp/vf/vf-colibri-eval-v3.dtsi | 2 +- arch/arm/boot/dts/nxp/vf/vf610-bk4.dts | 4 ++-- arch/arm/boot/dts/nxp/vf/vf610-zii-dev-rev-b.dts | 6 +++--- 20 files changed, 27 insertions(+), 27 deletions(-)