@@ -128,7 +128,8 @@ struct s3c64xx_spi_dma_data {
/**
* struct s3c64xx_spi_port_config - SPI Controller hardware info
- * @fifo_lvl_mask: Bit-mask for {TX|RX}_FIFO_LVL bits in SPI_STATUS register.
+ * @fifo_lvl_mask: [DEPRECATED] Bit-mask for {TX|RX}_FIFO_LVL bits in
+ * SPI_STATUS register.
* @rx_lvl_offset: Bit offset of RX_FIFO_LVL bits in SPI_STATUS regiter.
* @tx_st_done: Bit offset of TX_DONE bit in SPI_STATUS regiter.
* @clk_div: Internal clock divider
@@ -177,7 +178,7 @@ struct s3c64xx_spi_port_config {
* @rx_dma: Local receive DMA data (e.g. chan and direction)
* @tx_dma: Local transmit DMA data (e.g. chan and direction)
* @port_conf: Local SPI port configuartion data
- * @port_id: Port identification number
+ * @port_id: [DEPRECATED] Port identification number
* @fifosize: size of the FIFO for this port
*/
struct s3c64xx_spi_driver_data {
@@ -1152,7 +1153,7 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
sdd->pdev = pdev;
if (pdev->dev.of_node) {
ret = of_alias_get_id(pdev->dev.of_node, "spi");
- if (ret < 0)
+ if (ret < 0 && !sdd->port_conf->fifosize)
return dev_err_probe(&pdev->dev, ret,
"Failed to get alias id\n");
sdd->port_id = ret;
@@ -1171,7 +1172,7 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
sdd->rx_dma.direction = DMA_DEV_TO_MEM;
host->dev.of_node = pdev->dev.of_node;
- host->bus_num = sdd->port_id;
+ host->bus_num = -1;
host->setup = s3c64xx_spi_setup;
host->cleanup = s3c64xx_spi_cleanup;
host->prepare_transfer_hardware = s3c64xx_spi_prepare_transfer;
@@ -1252,7 +1253,7 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
}
dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Targets attached\n",
- sdd->port_id, host->num_chipselect);
+ host->bus_num, host->num_chipselect);
dev_dbg(&pdev->dev, "\tIOmem=[%pR]\tFIFO %dbytes\n",
mem_res, sdd->fifosize);
The alias was used to initialize the port_id, which unfortunately is used for older SoCs to determine the FIFO size from ``s3c64xx_spi_port_config.fifo_lvl_mask``. This is wrong all the way as we shouldn't make a driver dependable of an alias, or the order of probe. If multiple FIFO sizes are supported across the SPI IPs, one shall instead introduce a fifosize device tree property. Make the SPI alias optional for the newer SoCs and mark the ``port_id`` and ``fifo_lvl_mask`` as deprecated. Signed-off-by: Tudor Ambarus <tudor.ambarus@linaro.org> --- drivers/spi/spi-s3c64xx.c | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-)