| Message ID | 20240208110602.931573-4-b-kapoor@ti.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | arm64: dts: ti: Modify pinmux for wakeup and mcu uart | expand |
diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts index 57e7cb8ea2b8..9f16642ccd5f 100644 --- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts +++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts @@ -336,8 +336,6 @@ &wkup_pmx2 { wkup_uart0_pins_default: wkup-uart0-default-pins { bootph-all; pinctrl-single,pins = < - J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (L37) WKUP_GPIO0_6.WKUP_UART0_CTSn */ - J721S2_WKUP_IOPAD(0x074, PIN_INPUT, 0) /* (L36) WKUP_GPIO0_7.WKUP_UART0_RTSn */ J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (K35) WKUP_UART0_RXD */ J721S2_WKUP_IOPAD(0x04c, PIN_INPUT, 0) /* (K34) WKUP_UART0_TXD */ >;
Only Tx and Rx Signal lines for wake up uart are brought out on the J784S4 EVM from SoC, but CTS and RTS signal lines are not brought on the EVM. Thus, remove pinmux for CTS and RTS signal lines for wake up uart in J784S4. Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com> --- arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 -- 1 file changed, 2 deletions(-)