diff mbox series

[v2,3/4] ARM: dts: marvell: Add 7 segment LED display on x530

Message ID 20240227212244.262710-4-chris.packham@alliedtelesis.co.nz (mailing list archive)
State New, archived
Headers show
Series auxdisplay: 7 segment LED display | expand

Commit Message

Chris Packham Feb. 27, 2024, 9:22 p.m. UTC
The Allied Telesis x530 products have a 7 segment LED display which is
used for node identification when the devices are stacked. Represent
this as a gpio-7seg device.

Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>
---

Notes:
    Changes in v2:
    - Use compatible = "generic-gpio=7seg" to keep checkpatch.pl happy

 arch/arm/boot/dts/marvell/armada-385-atl-x530.dts | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

Comments

Andy Shevchenko Feb. 28, 2024, 12:12 a.m. UTC | #1
On Tue, Feb 27, 2024 at 11:22 PM Chris Packham
<chris.packham@alliedtelesis.co.nz> wrote:
>
> The Allied Telesis x530 products have a 7 segment LED display which is
> used for node identification when the devices are stacked. Represent
> this as a gpio-7seg device.

Please, be consistent with naming and references. I think the
compatible / driver name are the only two that should be used.

This also needs an Ack from the respective maintainer (I don't know
who that is, you might find in MAINTAINERS, though).
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts b/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
index 5a9ab8410b7b..f55a3dc6b6de 100644
--- a/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
+++ b/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
@@ -43,6 +43,17 @@  uart0: serial@12000 {
 			};
 		};
 	};
+
+	led-7seg {
+		compatible = "generic-gpio-7seg";
+		segment-gpios = <&led_7seg_gpio 0 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 1 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 2 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 3 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 4 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 5 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 6 GPIO_ACTIVE_LOW>;
+	};
 };
 
 &pciec {
@@ -149,7 +160,7 @@  i2c@3 {
 			#size-cells = <0>;
 			reg = <3>;
 
-			gpio@20 {
+			led_7seg_gpio: gpio@20 {
 				compatible = "nxp,pca9554";
 				gpio-controller;
 				#gpio-cells = <2>;