@@ -15,42 +15,42 @@ gpio-restart {
leds {
compatible = "gpio-leds";
- led@0 {
+ led-0 {
label = "eth60:yellow";
gpios = <&sgpio_out1 28 0 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@1 {
+ led-1 {
label = "eth60:green";
gpios = <&sgpio_out1 28 1 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@2 {
+ led-2 {
label = "eth61:yellow";
gpios = <&sgpio_out1 29 0 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@3 {
+ led-3 {
label = "eth61:green";
gpios = <&sgpio_out1 29 1 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@4 {
+ led-4 {
label = "eth62:yellow";
gpios = <&sgpio_out1 30 0 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@5 {
+ led-5 {
label = "eth62:green";
gpios = <&sgpio_out1 30 1 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@6 {
+ led-6 {
label = "eth63:yellow";
gpios = <&sgpio_out1 31 0 GPIO_ACTIVE_LOW>;
default-state = "off";
};
- led@7 {
+ led-7 {
label = "eth63:green";
gpios = <&sgpio_out1 31 1 GPIO_ACTIVE_LOW>;
default-state = "off";
GPIO leds should not have unit addresses (no "reg" property), as reported by dtc W=1 warnings: sparx5_pcb135_board.dtsi:18.9-22.5: Warning (unit_address_vs_reg): /leds/led@0: node has a unit name, but no reg or ranges property Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org> --- Changes in v2: 1. None --- .../boot/dts/microchip/sparx5_pcb135_board.dtsi | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)