diff mbox series

[v3,4/4] arm64: dts: exynos: gs101: enable ufs, phy on oriole & define ufs regulator

Message ID 20240426133824.2283144-5-peter.griffin@linaro.org (mailing list archive)
State New
Headers show
Series Enable UFS on gs101 / Pixel 6 (Oriole) | expand

Commit Message

Peter Griffin April 26, 2024, 1:38 p.m. UTC 
Enable ufs & ufs phy nodes for Oriole. Also define the ufs regulator node.

ufs regulator is a stub until full s2mpg11 slave pmic support is added.
The gpio defined is for the BOOTLD0 (gs101) signal connected to
UFS_EN(s2mpg11) gpio enabled voltage rail for UFS.

Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
---
 .../boot/dts/exynos/google/gs101-oriole.dts    | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/exynos/google/gs101-oriole.dts b/arch/arm64/boot/dts/exynos/google/gs101-oriole.dts
index 6be15e990b65..fb32f6ce2a4d 100644
--- a/arch/arm64/boot/dts/exynos/google/gs101-oriole.dts
+++ b/arch/arm64/boot/dts/exynos/google/gs101-oriole.dts
@@ -53,6 +53,15 @@  button-power {
 			wakeup-source;
 		};
 	};
+
+	/* TODO: Remove this once S2MPG11 slave PMIC is implemented  */
+	ufs_0_fixed_vcc_reg: regulator-0 {
+		compatible = "regulator-fixed";
+		regulator-name = "ufs-vcc";
+		gpio = <&gpp0 1 GPIO_ACTIVE_HIGH>;
+		regulator-boot-on;
+		enable-active-high;
+	};
 };
 
 &ext_24_5m {
@@ -106,6 +115,15 @@  &serial_0 {
 	status = "okay";
 };
 
+&ufs_0 {
+	status = "okay";
+	vcc-supply = <&ufs_0_fixed_vcc_reg>;
+};
+
+&ufs_0_phy {
+	status = "okay";
+};
+
 &usi_uart {
 	samsung,clkreq-on; /* needed for UART mode */
 	status = "okay";