@@ -13,6 +13,28 @@ pins {
};
};
+ goodix_pins_a: goodix-0 {
+ /*
+ * touchscreen reset needs to be configured
+ * via the pinctrl not the driver (a pull-down resistor
+ * has been soldered onto the reset line which forces
+ * the touchscreen to reset state).
+ */
+ pins1 {
+ pinmux = <STM32_PINMUX('H', 2, GPIO)>;
+ output-high;
+ bias-pull-up;
+ };
+ /*
+ * Interrupt line must have a pull-down resistor
+ * in order to freeze the i2c address at 0x5D
+ */
+ pins2 {
+ pinmux = <STM32_PINMUX('F', 5, GPIO)>;
+ bias-pull-down;
+ };
+ };
+
i2c1_pins_a: i2c1-0 {
pins {
pinmux = <STM32_PINMUX('D', 12, AF5)>, /* I2C1_SCL */
@@ -201,6 +201,20 @@ &i2c5 {
/* spare dmas for other usage */
/delete-property/dmas;
/delete-property/dma-names;
+
+ goodix: goodix-ts@5d {
+ compatible = "goodix,gt911";
+ reg = <0x5d>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&goodix_pins_a>;
+ interrupt-parent = <&gpiof>;
+ interrupts = <5 IRQ_TYPE_EDGE_FALLING>;
+ AVDD28-supply = <&scmi_v3v3_sw>;
+ VDDIO-supply = <&scmi_v3v3_sw>;
+ touchscreen-size-x = <480>;
+ touchscreen-size-y = <272>;
+ status = "okay" ;
+ };
};
&iwdg2 {
Touchscreen reset needs to be configured via the pinctrl not the driver (a pull-down resistor has been soldered onto the reset line which forces the touchscreen to reset state). Interrupt line must have a pull-down resistor in order to freeze the i2c address at 0x5D. Signed-off-by: Yannick Fertre <yannick.fertre@foss.st.com> --- arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi | 22 +++++++++++++++++++++ arch/arm/boot/dts/st/stm32mp135f-dk.dts | 14 +++++++++++++ 2 files changed, 36 insertions(+)