@@ -139,13 +139,17 @@ wkup_gpio_intr: interrupt-controller@42200000 {
ti,interrupt-ranges = <16 960 16>;
};
- mcu_conf: syscon@40f00000 {
- compatible = "syscon", "simple-mfd";
- reg = <0x0 0x40f00000 0x0 0x20000>;
+ mcu_conf: bus@40f00000 {
+ compatible = "simple-bus";
#address-cells = <1>;
#size-cells = <1>;
ranges = <0x0 0x0 0x40f00000 0x20000>;
+ cpsw_mac_syscon: ethernet-mac-syscon@200 {
+ compatible = "ti,am62p-cpsw-mac-efuse", "syscon";
+ reg = <0x200 0x8>;
+ };
+
phy_gmii_sel: phy@4040 {
compatible = "ti,am654-phy-gmii-sel";
reg = <0x4040 0x4>;
@@ -544,7 +548,7 @@ cpsw_port1: port@1 {
reg = <1>;
ti,mac-only;
label = "port1";
- ti,syscon-efuse = <&mcu_conf 0x200>;
+ ti,syscon-efuse = <&cpsw_mac_syscon 0x0>;
phys = <&phy_gmii_sel 1>;
};
};
The MCU system controller address region contains an eFuse block with MAC addresses to be used by the Ethernet controller. The property “ti,syscon-efuse” contains a phandle to a syscon region and an offset into this region where the MAC addresses can be found. Currently "ti,syscon-efuse" points to the entire system controller address space node with an offset to the eFuse IP address. Instead add a cpsw-mac-efuse node to describe the exact eFuse area. Then point the Ethernet controller directly to this region, no offset needed. This makes it so the system controller memory area does not need to be one big syscon area, describe this bus address area as the simple-bus it is. Signed-off-by: Andrew Davis <afd@ti.com> --- arch/arm64/boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-)