@@ -42,6 +42,11 @@ reg_vcc1v8: vcc1v8 {
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
};
+
+ wifi_pwrseq: pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
+ };
};
&ac_power_supply {
@@ -103,6 +108,17 @@ ext_rgmii_phy: ethernet-phy@1 {
};
};
+/* On Wifi/BT connector */
+&mmc1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc1_pins>;
+ vmmc-supply = <®_dldo4>;
+ vqmmc-supply = <®_eldo1>;
+ mmc-pwrseq = <&wifi_pwrseq>;
+ bus-width = <4>;
+ non-removable;
+};
+
&mmc2 {
pinctrl-names = "default";
pinctrl-0 = <&mmc2_pins>;
@@ -175,6 +191,14 @@ &uart0 {
status = "okay";
};
+/* On Wifi/BT connector, with RTS/CTS */
+&uart1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+ uart-has-rtscts;
+ status = "disabled";
+};
+
/* On Pi-2 connector */
&uart2 {
pinctrl-names = "default";
This adds all the pin mappings on the WiFi/BT header on the SoPine baseboard/A64-LTS. They're disabled by default as the modules don't ship by default. This includes, where they haven't been already, UART1 for BT and mmc1 for WiFi. Signed-off-by: Peter Robinson <pbrobinson@gmail.com> --- .../allwinner/sun50i-a64-sopine-baseboard.dts | 24 +++++++++++++++++++ 1 file changed, 24 insertions(+)