@@ -15,6 +15,7 @@
#include <unistd.h>
#include <sys/ioctl.h>
#include <linux/gpio.h>
+#include <stdbool.h>
#define CONSUMER "gpio-mockup-cdev"
@@ -95,6 +96,7 @@ static void usage(char *prog)
printf(" (default is to leave bias unchanged):\n");
printf(" -l: set line active low (default is active high)\n");
printf(" -s: set line value (default is to get line value)\n");
+ printf(" -w: wait even in get mode\n");
printf(" -u: uAPI version to use (default is 2)\n");
exit(-1);
}
@@ -120,13 +122,14 @@ int main(int argc, char *argv[])
unsigned int offset, val = 0, abiv;
uint32_t flags_v1;
uint64_t flags_v2;
+ bool wait = false;
abiv = 2;
ret = 0;
flags_v1 = GPIOHANDLE_REQUEST_INPUT;
flags_v2 = GPIO_V2_LINE_FLAG_INPUT;
- while ((opt = getopt(argc, argv, "lb:s:u:")) != -1) {
+ while ((opt = getopt(argc, argv, "lb:s:u:w")) != -1) {
switch (opt) {
case 'l':
flags_v1 |= GPIOHANDLE_REQUEST_ACTIVE_LOW;
@@ -150,10 +153,14 @@ int main(int argc, char *argv[])
flags_v1 |= GPIOHANDLE_REQUEST_OUTPUT;
flags_v2 &= ~GPIO_V2_LINE_FLAG_INPUT;
flags_v2 |= GPIO_V2_LINE_FLAG_OUTPUT;
+ wait = true;
break;
case 'u':
abiv = atoi(optarg);
break;
+ case 'w':
+ wait = true;
+ break;
default:
usage(argv[0]);
}
@@ -183,9 +190,10 @@ int main(int argc, char *argv[])
return lfd;
}
- if (flags_v2 & GPIO_V2_LINE_FLAG_OUTPUT) {
+ if (wait)
wait_signal();
- } else {
+
+ if (flags_v2 & GPIO_V2_LINE_FLAG_INPUT) {
if (abiv == 1)
ret = get_value_v1(lfd);
else
Add a -w flag to the gpio-mockup-cdev utility that causes the program to wait until a signal is received before exiting, even when its behavior is to retrieve the GPIO value of the line. This allows using this utility to keep a GPIO line configured even when in input mode, which will be relied on in other tests. Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com> --- tools/testing/selftests/gpio/gpio-mockup-cdev.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-)