| Message ID | 20240925-qcs8300_initial_dtsi-v2-2-494c40fa2a42@quicinc.com (mailing list archive) |
|---|---|
| State | New |
| Headers | show |
| Series | Add initial support for QCS8300 SoC and QCS8300 RIDE board | expand |
On 25/09/2024 12:43, Jingyi Wang wrote: > Enable clock controller, interconnect and pinctrl for Qualcomm > QCS8300 platform to boot to UART console. > > The serial engine depends on gcc, interconnect and pinctrl. Since > the serial console driver is only available as built-in, so these > configs needs be built-in for the UART device to probe and register > the console. > > Signed-off-by: Jingyi Wang <quic_jingyw@quicinc.com> > --- Reviewed-by: Krzysztof Kozlowski <krzk@kernel.org> Best regards, Krzysztof
diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig index 5fdbfea7a5b2..0b5634ceeaff 100644 --- a/arch/arm64/configs/defconfig +++ b/arch/arm64/configs/defconfig @@ -607,6 +607,7 @@ CONFIG_PINCTRL_MSM8996=y CONFIG_PINCTRL_MSM8998=y CONFIG_PINCTRL_QCM2290=y CONFIG_PINCTRL_QCS404=y +CONFIG_PINCTRL_QCS8300=y CONFIG_PINCTRL_QDF2XXX=y CONFIG_PINCTRL_QDU1000=y CONFIG_PINCTRL_SA8775P=y @@ -1323,6 +1324,7 @@ CONFIG_MSM_MMCC_8998=m CONFIG_QCM_GCC_2290=y CONFIG_QCM_DISPCC_2290=m CONFIG_QCS_GCC_404=y +CONFIG_QCS_GCC_8300=y CONFIG_QDU_GCC_1000=y CONFIG_SC_CAMCC_8280XP=m CONFIG_SC_DISPCC_7280=m @@ -1625,6 +1627,7 @@ CONFIG_INTERCONNECT_QCOM_MSM8996=y CONFIG_INTERCONNECT_QCOM_OSM_L3=m CONFIG_INTERCONNECT_QCOM_QCM2290=y CONFIG_INTERCONNECT_QCOM_QCS404=m +CONFIG_INTERCONNECT_QCOM_QCS8300=y CONFIG_INTERCONNECT_QCOM_QDU1000=y CONFIG_INTERCONNECT_QCOM_SA8775P=y CONFIG_INTERCONNECT_QCOM_SC7180=y
Enable clock controller, interconnect and pinctrl for Qualcomm QCS8300 platform to boot to UART console. The serial engine depends on gcc, interconnect and pinctrl. Since the serial console driver is only available as built-in, so these configs needs be built-in for the UART device to probe and register the console. Signed-off-by: Jingyi Wang <quic_jingyw@quicinc.com> --- arch/arm64/configs/defconfig | 3 +++ 1 file changed, 3 insertions(+)