@@ -23,7 +23,7 @@ touchscreen1: touchscreen@5d {
interrupts-extended = <&pio 155 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&pio 156 GPIO_ACTIVE_LOW>;
- vdd-supply = <&lcd_pp3300>;
+ vdd-supply = <&pp3300_alw>;
};
};
@@ -23,7 +23,7 @@ touchscreen1: touchscreen@5d {
interrupts-extended = <&pio 155 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&pio 156 GPIO_ACTIVE_LOW>;
- vdd-supply = <&lcd_pp3300>;
+ vdd-supply = <&pp3300_alw>;
};
};
@@ -52,27 +52,6 @@ it6505_pp18_reg: regulator0 {
vin-supply = <&pp1800_alw>;
};
- lcd_pp3300: regulator1 {
- compatible = "regulator-fixed";
- regulator-name = "lcd_pp3300";
- regulator-min-microvolt = <3300000>;
- regulator-max-microvolt = <3300000>;
- regulator-always-on;
- regulator-boot-on;
- };
-
- mmc1_fixed_power: regulator3 {
- compatible = "regulator-fixed";
- regulator-name = "mmc1_power";
- vin-supply = <&pp3300_alw>;
- };
-
- mmc1_fixed_io: regulator4 {
- compatible = "regulator-fixed";
- regulator-name = "mmc1_io";
- vin-supply = <&pp1800_alw>;
- };
-
pp1800_alw: regulator5 {
compatible = "regulator-fixed";
regulator-name = "pp1800_alw";
@@ -373,8 +352,8 @@ &mmc1 {
pinctrl-names = "default", "state_uhs";
pinctrl-0 = <&mmc1_pins_default>;
pinctrl-1 = <&mmc1_pins_uhs>;
- vmmc-supply = <&mmc1_fixed_power>;
- vqmmc-supply = <&mmc1_fixed_io>;
+ vmmc-supply = <&pp3300_alw>;
+ vqmmc-supply = <&pp1800_alw>;
mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
max-frequency = <200000000>;
A couple of the fixed regulators in the Kukui dtsi do not actually exist in the hardware design; they are simply power rails connected together with 0 ohm bridges. Drop them and assign their upstream supplies to their consumers instead. Signed-off-by: Chen-Yu Tsai <wenst@chromium.org> --- .../dts/mediatek/mt8183-kukui-katsu-sku32.dts | 2 +- .../dts/mediatek/mt8183-kukui-katsu-sku38.dts | 2 +- .../arm64/boot/dts/mediatek/mt8183-kukui.dtsi | 25 ++----------------- 3 files changed, 4 insertions(+), 25 deletions(-)