@@ -304,7 +304,7 @@ pins 50..69.
It is also possible to use pin groups for gpio ranges when pin groups are the
easiest and most convenient mapping.
-Both both <pinctrl-base> and <count> must set to 0 when using named pin groups
+Both <pinctrl-base> and <count> must set to 0 when using named pin groups
names.
The property gpio-ranges-group-names must contain exactly one string for each
@@ -43,7 +43,7 @@ Read parameters:
- devbus,bus-width: Defines the bus width, in bits (e.g. <16>).
Mandatory, except if devbus,keep-config is used.
- - devbus,badr-skew-ps: Defines the time delay from from A[2:0] toggle,
+ - devbus,badr-skew-ps: Defines the time delay from A[2:0] toggle,
to read data sample. This parameter is useful for
synchronous pipelined devices, where the address
precedes the read data by one or two cycles.
@@ -15,7 +15,7 @@ Properties:
- #size-cells: Must be <1>.
-- ranges: There must be one one triplet of (child-bus-address,
+- ranges: There must be one triplet of (child-bus-address,
parent-bus-address, length) for each active chip select. If the
length element for any triplet is zero, the chip select is disabled,
making it inactive.
@@ -18,7 +18,7 @@ states. The number and names of those states is defined by the client device's
own binding.
The common pinctrl bindings defined in this file provide an infrastructure
-for client device device tree nodes to map those state names to the pin
+for client device tree nodes to map those state names to the pin
configuration used by those states.
Note that pin controllers themselves may also be client devices of themselves.
@@ -3,7 +3,7 @@ Freescale QUICC Engine USB Controller
Required properties:
- compatible : should be "fsl,<chip>-qe-usb", "fsl,mpc8323-qe-usb".
- reg : the first two cells should contain usb registers location and
- length, the next two two cells should contain PRAM location and
+ length, the next two cells should contain PRAM location and
length.
- interrupts : should contain USB interrupt.
- fsl,fullspeed-clock : specifies the full speed USB clock source:
Fix unintentional word repetitions in devicetree binding documentation: - usb.txt: Fix repeated "two" - mvebu-devbus.txt: Fix repeated "from" - gpio.txt: Fix repeated "Both" - pinctrl-bindings.txt: Fix repeated "device" - cavium/bootbus.txt: Fix repeated "one" These issues were identified using the checkpatch.pl script. Signed-off-by: Abhinav Saxena <xandfury@gmail.com> --- Documentation/devicetree/bindings/gpio/gpio.txt | 2 +- .../devicetree/bindings/memory-controllers/mvebu-devbus.txt | 2 +- Documentation/devicetree/bindings/mips/cavium/bootbus.txt | 2 +- Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt | 2 +- Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/usb.txt | 2 +- 5 files changed, 5 insertions(+), 5 deletions(-)