@@ -198,6 +198,52 @@ regulator-state-standby {
};
};
+&flx7 {
+ atmel,flexcom-mode = <ATMEL_FLEXCOM_MODE_TWI>;
+ status = "okay";
+};
+
+&i2c7 {
+ dmas = <0>, <0>;
+ i2c-analog-filter;
+ i2c-digital-filter;
+ i2c-digital-filter-width-ns = <35>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_flx7_default>;
+ status = "okay";
+
+ power-monitor@10 {
+ compatible = "microchip,pac1934";
+ reg = <0x10>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ channel@1 {
+ reg = <0x1>;
+ shunt-resistor-micro-ohms = <10000>;
+ label = "VDD3V3";
+ };
+
+ channel@2 {
+ reg = <0x2>;
+ shunt-resistor-micro-ohms = <10000>;
+ label = "VDDOUT4";
+ };
+
+ channel@3 {
+ reg = <0x3>;
+ shunt-resistor-micro-ohms = <10000>;
+ label = "VDDCORE";
+ };
+
+ channel@4 {
+ reg = <0x4>;
+ shunt-resistor-micro-ohms = <10000>;
+ label = "VDDIODDR";
+ };
+ };
+};
+
&i2s {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2s_default>;
@@ -231,6 +277,12 @@ pinctrl_flx6_default: flx6-default {
<AT91_PIOA 24 AT91_PERIPH_A AT91_PINCTRL_PULL_UP>,
<AT91_PIOA 25 AT91_PERIPH_A AT91_PINCTRL_PULL_UP>;
};
+
+ pinctrl_flx7_default: flx7-default {
+ atmel,pins =
+ <AT91_PIOC 0 AT91_PERIPH_C AT91_PINCTRL_PULL_UP>,
+ <AT91_PIOC 1 AT91_PERIPH_C AT91_PINCTRL_PULL_UP>;
+ };
};
gpio-keys {
Add PAC1934 support in order to monitor the board power consumption. Device is connected on flexcom7 in twi mode. [root@SAM9X75 ~]$ awk -f pac1934.awk VDD3V3 current: 10.675 mA, voltage: 3295.41 mV VDDOUT4 current: 5.7625 mA, voltage: 1196.78 mV VDDCORE current: 115.442 mA, voltage: 1243.65 mV VDDIODDR current: 29.585 mA, voltage: 1345.21 mV Signed-off-by: Mihai Sain <mihai.sain@microchip.com> --- .../dts/microchip/at91-sam9x75_curiosity.dts | 52 +++++++++++++++++++ 1 file changed, 52 insertions(+)