@@ -711,8 +711,8 @@ reg_vdd1p1: regulator-1p1 {
reg_vdd3p0: regulator-3p0 {
compatible = "fsl,anatop-regulator";
regulator-name = "vdd3p0";
- regulator-min-microvolt = <2800000>;
- regulator-max-microvolt = <3150000>;
+ regulator-min-microvolt = <2625000>;
+ regulator-max-microvolt = <3400000>;
regulator-always-on;
anatop-reg-offset = <0x120>;
anatop-vol-bit-shift = <8>;
@@ -806,6 +806,7 @@ usbphy1: usbphy@20c9000 {
reg = <0x020c9000 0x1000>;
interrupts = <0 44 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clks IMX6QDL_CLK_USBPHY1>;
+ phy-3p0-supply = <®_vdd3p0>;
fsl,anatop = <&anatop>;
};
@@ -814,6 +815,7 @@ usbphy2: usbphy@20ca000 {
reg = <0x020ca000 0x1000>;
interrupts = <0 45 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clks IMX6QDL_CLK_USBPHY2>;
+ phy-3p0-supply = <®_vdd3p0>;
fsl,anatop = <&anatop>;
};
The integrated usb phys are supplied by the 3p0 regulator, which has a voltage range of 2.625V to 3.4V. Thus the min and max values are corrected and the regulator added as a proper supply for the usb phys. This fixes the following warnings during the probe of the mxs_phy driver: mxs_phy 20c9000.usbphy: supply phy-3p0 not found, using dummy regulator mxs_phy 20ca000.usbphy: supply phy-3p0 not found, using dummy regulator The 3p0 regulator handling was introduced by commit 966d73152078 ("usb: phy: mxs: enable regulator phy-3p0 to improve signal qualilty")`. Signed-off-by: Stefan Kerkmann <s.kerkmann@pengutronix.de> --- arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)