@@ -33,6 +33,7 @@ struct rk_gmac_ops {
void (*set_clock_selection)(struct rk_priv_data *bsp_priv, bool input,
bool enable);
void (*integrated_phy_powerup)(struct rk_priv_data *bsp_priv);
+ bool php_grf_required;
bool regs_valid;
u32 regs[];
};
@@ -1254,6 +1255,7 @@ static const struct rk_gmac_ops rk3576_ops = {
.set_rgmii_speed = rk3576_set_gmac_speed,
.set_rmii_speed = rk3576_set_gmac_speed,
.set_clock_selection = rk3576_set_clock_selection,
+ .php_grf_required = true,
.regs_valid = true,
.regs = {
0x2a220000, /* gmac0 */
@@ -1401,6 +1403,7 @@ static const struct rk_gmac_ops rk3588_ops = {
.set_rgmii_speed = rk3588_set_gmac_speed,
.set_rmii_speed = rk3588_set_gmac_speed,
.set_clock_selection = rk3588_set_clock_selection,
+ .php_grf_required = true,
.regs_valid = true,
.regs = {
0xfe1b0000, /* gmac0 */
@@ -1812,8 +1815,22 @@ static struct rk_priv_data *rk_gmac_setup(struct platform_device *pdev,
bsp_priv->grf = syscon_regmap_lookup_by_phandle(dev->of_node,
"rockchip,grf");
- bsp_priv->php_grf = syscon_regmap_lookup_by_phandle(dev->of_node,
- "rockchip,php-grf");
+ if (IS_ERR(bsp_priv->grf)) {
+ dev_err_probe(dev, PTR_ERR(bsp_priv->grf),
+ "failed to lookup rockchip,grf\n");
+ return ERR_CAST(bsp_priv->grf);
+ }
+
+ if (ops->php_grf_required) {
+ bsp_priv->php_grf =
+ syscon_regmap_lookup_by_phandle(dev->of_node,
+ "rockchip,php-grf");
+ if (IS_ERR(bsp_priv->php_grf)) {
+ dev_err_probe(dev, PTR_ERR(bsp_priv->php_grf),
+ "failed to lookup rockchip,php-grf\n");
+ return ERR_CAST(bsp_priv->php_grf);
+ }
+ }
if (plat->phy_node) {
bsp_priv->integrated_phy = of_property_read_bool(plat->phy_node,
All Rockchip GMAC variants typically write to GRF regs to control e.g. interface mode, speed and MAC rx/tx delay. Newer SoCs such as RK3576 and RK3588 use a mix of GRF and peripheral GRF regs. These syscon regmaps is located with help of a rockchip,grf and rockchip,php-grf phandle. However, validating the rockchip,grf and rockchip,php-grf syscon regmap is deferred until e.g. interface mode or speed is configured, inside the individual SoC specific operations. Change to validate the rockchip,grf and rockchip,php-grf syscon regmap at probe time to simplify all SoC specific operations. This should not introduce any backward compatibility issues as all GMAC nodes have been added together with a rockchip,grf phandle (and rockchip,php-grf where required) in their initial commit. Signed-off-by: Jonas Karlman <jonas@kwiboo.se> --- Changes in v2: - Split removal of the IS_ERR() check in each SoC specific operation to a separate patch - Add a php_grf_required flag to indicate when peripheral GRF is required - Only lookup rockchip,php-grf phandle when php_grf_required is true - Use ERR_CAST() instead of ERR_PTR() The pending addition of RK3562 support [1] must be adjusted to set .php_grf_required = true, or this will break RK3562 support. [1] https://lore.kernel.org/r/20250227110652.2342729-2-kever.yang@rock-chips.com/ --- .../net/ethernet/stmicro/stmmac/dwmac-rk.c | 21 +++++++++++++++++-- 1 file changed, 19 insertions(+), 2 deletions(-)