@@ -2324,7 +2324,7 @@ uart_A: serial@24000 {
sd_emmc_a: sd@ffe03000 {
compatible = "amlogic,meson-axg-mmc";
reg = <0x0 0xffe03000 0x0 0x800>;
- interrupts = <GIC_SPI 189 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <GIC_SPI 189 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
clocks = <&clkc CLKID_SD_EMMC_A>,
<&clkc CLKID_SD_EMMC_A_CLK0>,
@@ -2336,7 +2336,7 @@ sd_emmc_a: sd@ffe03000 {
sd_emmc_b: sd@ffe05000 {
compatible = "amlogic,meson-axg-mmc";
reg = <0x0 0xffe05000 0x0 0x800>;
- interrupts = <GIC_SPI 190 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <GIC_SPI 190 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
clocks = <&clkc CLKID_SD_EMMC_B>,
<&clkc CLKID_SD_EMMC_B_CLK0>,
@@ -2348,7 +2348,7 @@ sd_emmc_b: sd@ffe05000 {
sd_emmc_c: mmc@ffe07000 {
compatible = "amlogic,meson-axg-mmc";
reg = <0x0 0xffe07000 0x0 0x800>;
- interrupts = <GIC_SPI 191 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <GIC_SPI 191 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
clocks = <&clkc CLKID_SD_EMMC_C>,
<&clkc CLKID_SD_EMMC_C_CLK0>,
The usage of edge-triggered interrupts lead to lost interrupts under load, see [0]. This was confirmed to be fixed by using level-triggered interrupts. The report was about SDIO. However, as the host controller is the same for SD and MMC, apply the change to all mmc controller instances. [0] https://www.spinics.net/lists/linux-mmc/msg73991.html Fixes: 4759fd87b928 ("arm64: dts: meson: g12a: add mmc nodes") Tested-by: FUKAUMI Naoki <naoki@radxa.com> Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> Tested-by: Jerome Brunet <jbrunet@baylibre.com> Cc: stable@vger.kernel.org Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com> --- arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)