@@ -21,6 +21,7 @@
serial3 = &usart2;
serial4 = &usart3;
serial5 = &uart0;
+ serial6 = &uart1;
};
chosen {
@@ -112,13 +113,17 @@
status = "okay";
};
+ /*
+ * UART0/1 pins are marked as GPIO on
+ * Aria documentation.
+ * Change to "okay" if you need additional serial ports
+ */
uart0: serial@f8040000 {
- compatible = "atmel,at91sam9260-usart";
- reg = <0xf8040000 0x200>;
- interrupts = <15 4 5>;
- pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_uart0>;
- status = "okay";
+ status = "disabled";
+ };
+
+ uart1: serial@f8044000 {
+ status = "disabled";
};
adc0: adc@f804c000 {
UART0 is moved to generic at91sam9x5.dtsi file. Both uarts are "disabled" as the corresponding pins on Aria documentation are shown as GPIOs. Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com> --- arch/arm/boot/dts/at91-ariag25.dts | 17 +++++++++++------ 1 file changed, 11 insertions(+), 6 deletions(-)