@@ -79,7 +79,7 @@
pinctrl@20008000 {
compatible = "rockchip,rk3066a-pinctrl";
- reg = <0x20008000 0x150>;
+ rockchip,grf = <&grf>;
#address-cells = <1>;
#size-cells = <1>;
ranges;
@@ -75,17 +75,16 @@
pinctrl@20008000 {
compatible = "rockchip,rk3188-pinctrl";
- reg = <0x20008000 0xa0>,
- <0x20008164 0x1a0>;
- reg-names = "base", "pull";
+ rockchip,grf = <&grf>;
+ rockchip,pmu = <&pmu>;
+
#address-cells = <1>;
#size-cells = <1>;
ranges;
gpio0: gpio0@0x2000a000 {
compatible = "rockchip,rk3188-gpio-bank0";
- reg = <0x2000a000 0x100>,
- <0x20004064 0x8>;
+ reg = <0x2000a000 0x100>;
interrupts = <GIC_SPI 54 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk_gates8 9>;
@@ -31,11 +31,16 @@
reg = <0x1013c000 0x100>;
};
- pmu@20004000 {
- compatible = "rockchip,rk3066-pmu";
+ pmu: pmu@20004000 {
+ compatible = "rockchip,rk3066-pmu", "syscon";
reg = <0x20004000 0x100>;
};
+ grf: grf@20008000 {
+ compatible = "syscon";
+ reg = <0x20008000 0x200>;
+ };
+
gic: interrupt-controller@1013d000 {
compatible = "arm,cortex-a9-gic";
interrupt-controller;
Introduce the grf syscon and convert the pinctrl drivers for rk3066 and rk3188 to use it, instead of mapping the grf registers themselfs. Signed-off-by: Heiko Stuebner <heiko@sntech.de> --- arch/arm/boot/dts/rk3066a.dtsi | 2 +- arch/arm/boot/dts/rk3188.dtsi | 9 ++++----- arch/arm/boot/dts/rk3xxx.dtsi | 9 +++++++-- 3 files changed, 12 insertions(+), 8 deletions(-)