@@ -632,25 +632,30 @@ static void mv88e6xxx_mac_config(struct dsa_switch *ds, int port,
dev_err(ds->dev, "p%d: failed to configure MAC\n", port);
}
-static void mv88e6xxx_mac_link_force(struct dsa_switch *ds, int port, int link)
+static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port,
+ unsigned int mode,
+ phy_interface_t interface)
{
struct mv88e6xxx_chip *chip = ds->priv;
- int err;
+ const struct mv88e6xxx_ops *ops;
+ int err = 0;
- mv88e6xxx_reg_lock(chip);
- err = chip->info->ops->port_set_link(chip, port, link);
- mv88e6xxx_reg_unlock(chip);
+ ops = chip->info->ops;
- if (err)
- dev_err(chip->dev, "p%d: failed to force MAC link\n", port);
-}
+ /* Internal PHYs propagate their configuration directly to the MAC.
+ * External PHYs depend on whether the PPU is enabled for this port.
+ * FIXME: we should be using the PPU enable state here. What about
+ * an automedia port?
+ */
+ if (!mv88e6xxx_phy_is_internal(ds, port) && ops->port_set_link) {
+ mv88e6xxx_reg_lock(chip);
+ err = ops->port_set_link(chip, port, LINK_FORCED_DOWN);
+ mv88e6xxx_reg_unlock(chip);
-static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port,
- unsigned int mode,
- phy_interface_t interface)
-{
- if (mode == MLO_AN_FIXED)
- mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_DOWN);
+ if (err)
+ dev_err(chip->dev,
+ "p%d: failed to force MAC link down\n", port);
+ }
}
static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port,
@@ -659,8 +664,46 @@ static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port,
int speed, int duplex,
bool tx_pause, bool rx_pause)
{
- if (mode == MLO_AN_FIXED)
- mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_UP);
+ struct mv88e6xxx_chip *chip = ds->priv;
+ const struct mv88e6xxx_ops *ops;
+ int err = 0;
+
+ ops = chip->info->ops;
+
+ /* Internal PHYs propagate their configuration directly to the MAC.
+ * External PHYs depend on whether the PPU is enabled for this port.
+ * FIXME: we should be using the PPU enable state here. What about
+ * an automedia port?
+ */
+ if (!mv88e6xxx_phy_is_internal(ds, port)) {
+ mv88e6xxx_reg_lock(chip);
+ /* FIXME: for an automedia port, should we force the link
+ * down here - what if the link comes up due to "other" media
+ * while we're bringing the port up, how is the exclusivity
+ * handled in the Marvell hardware? E.g. port 4 on 88E6532
+ * shared between internal PHY and Serdes.
+ */
+ if (ops->port_set_speed) {
+ err = ops->port_set_speed(chip, port, speed);
+ if (err && err != -EOPNOTSUPP)
+ goto error;
+ }
+
+ if (ops->port_set_duplex) {
+ err = ops->port_set_duplex(chip, port, duplex);
+ if (err && err != -EOPNOTSUPP)
+ goto error;
+ }
+
+ if (ops->port_set_link)
+ err = ops->port_set_link(chip, port, LINK_FORCED_UP);
+error:
+ mv88e6xxx_reg_unlock(chip);
+
+ if (err && err != -EOPNOTSUPP)
+ dev_err(ds->dev,
+ "p%d: failed to configure MAC link up\n", port);
+ }
}
static int mv88e6xxx_stats_snapshot(struct mv88e6xxx_chip *chip, int port)
Use the resolved link configuration to set the MAC configuration when mac_link_up() for non-internal-PHY ports. Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk> --- drivers/net/dsa/mv88e6xxx/chip.c | 75 +++++++++++++++++++++++++------- 1 file changed, 59 insertions(+), 16 deletions(-)