@@ -400,8 +400,8 @@ static void mtk_mac_config(struct phylink_config *config, unsigned int mode,
if (err)
goto init_err;
- regmap_update_bits(eth->ethsys, ETHSYS_SYSCFG0,
- SYSCFG0_SGMII_MASK, val);
+ /* Save the syscfg0 value for mac_finish */
+ mac->syscfg0 = val;
} else if (phylink_autoneg_inband(mode)) {
dev_err(eth->dev,
"In-band mode not supported in non SGMII mode!\n");
@@ -425,8 +425,15 @@ static int mtk_mac_finish(struct phylink_config *config, unsigned int mode,
{
struct mtk_mac *mac = container_of(config, struct mtk_mac,
phylink_config);
+ struct mtk_eth *eth = mac->hw;
u32 mcr_cur, mcr_new;
+ /* Enable SGMII */
+ if (interface == PHY_INTERFACE_MODE_SGMII ||
+ phy_interface_mode_is_8023z(interface))
+ regmap_update_bits(eth->ethsys, ETHSYS_SYSCFG0,
+ SYSCFG0_SGMII_MASK, mac->syscfg0);
+
/* Setup gmac */
mcr_cur = mtk_r32(mac->hw, MTK_MAC_MCR(mac->id));
mcr_new = mcr_cur;
@@ -1001,6 +1001,7 @@ struct mtk_mac {
struct mtk_hw_stats *hw_stats;
__be32 hwlro_ip[MTK_MAX_LRO_IP_CNT];
int hwlro_ip_cnt;
+ unsigned int syscfg0;
};
/* the struct describing the SoC. these are declared in the soc_xyz.c files */
The SGMIISYS configuration is performed while ETHSYS_SYSCFG0 is in a disabled state. In order to preserve this when we switch to phylink_pcs we need to move the restoration of this register to the mac_finish() callback. Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk> --- drivers/net/ethernet/mediatek/mtk_eth_soc.c | 11 +++++++++-- drivers/net/ethernet/mediatek/mtk_eth_soc.h | 1 + 2 files changed, 10 insertions(+), 2 deletions(-)