@@ -185,7 +185,8 @@ static int sti_dwmac_set_mode(struct sti_dwmac *dwmac)
}
static int sti_dwmac_parse_data(struct sti_dwmac *dwmac,
- struct platform_device *pdev)
+ struct platform_device *pdev,
+ struct plat_stmmacenet_data *plat_dat)
{
struct resource *res;
struct device *dev = &pdev->dev;
@@ -204,12 +205,7 @@ static int sti_dwmac_parse_data(struct sti_dwmac *dwmac,
if (IS_ERR(regmap))
return PTR_ERR(regmap);
- err = of_get_phy_mode(np, &dwmac->interface);
- if (err && err != -ENODEV) {
- dev_err(dev, "Can't get phy-mode\n");
- return err;
- }
-
+ dwmac->interface = plat_dat->phy_interface;
dwmac->regmap = regmap;
dwmac->gmac_en = of_property_read_bool(np, "st,gmac_en");
dwmac->ext_phyclk = of_property_read_bool(np, "st,ext-phyclk");
@@ -268,7 +264,7 @@ static int sti_dwmac_probe(struct platform_device *pdev)
if (!dwmac)
return -ENOMEM;
- ret = sti_dwmac_parse_data(dwmac, pdev);
+ ret = sti_dwmac_parse_data(dwmac, pdev, plat_dat);
if (ret) {
dev_err(&pdev->dev, "Unable to parse OF data\n");
return ret;
devm_stmmac_probe_config_dt() already gets the PHY mode from firmware, which is stored in plat_dat->phy_interface. Therefore, we don't need to get it in platform code. Pass plat_dat into sti_dwmac_parse_data(), and set dwmac->interface from plat_dat->phy_interface. Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk> --- drivers/net/ethernet/stmicro/stmmac/dwmac-sti.c | 12 ++++-------- 1 file changed, 4 insertions(+), 8 deletions(-)