diff mbox

[v2,06/10] pinctrl: axp209: add support for AXP813 GPIOs

Message ID b950efcbb2f4d399812591cdf5dce11d0d35b42b.1506428208.git-series.quentin.schulz@free-electrons.com (mailing list archive)
State New, archived
Headers show

Commit Message

Quentin Schulz Sept. 26, 2017, 12:17 p.m. UTC
The AXP813 has only two GPIOs. GPIO0 can either be used as a GPIO, an
LDO regulator or an ADC. GPIO1 can be used either as a GPIO or an LDO
regulator.

Moreover, the status bit of the GPIOs when in input mode is not offset
by 4 unlike the AXP209.

Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com>
---
 Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt | 13 ++-
 drivers/pinctrl/pinctrl-axp209.c                             | 30 ++++++-
 2 files changed, 39 insertions(+), 4 deletions(-)

Comments

Maxime Ripard Sept. 26, 2017, 1:12 p.m. UTC | #1
On Tue, Sep 26, 2017 at 12:17:16PM +0000, Quentin Schulz wrote:
> The AXP813 has only two GPIOs. GPIO0 can either be used as a GPIO, an
> LDO regulator or an ADC. GPIO1 can be used either as a GPIO or an LDO
> regulator.
> 
> Moreover, the status bit of the GPIOs when in input mode is not offset
> by 4 unlike the AXP209.
> 
> Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com>
> ---
>  Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt | 13 ++-
>  drivers/pinctrl/pinctrl-axp209.c                             | 30 ++++++-
>  2 files changed, 39 insertions(+), 4 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
> index a5bfe87..a1d5dec 100644
> --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
> +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
> @@ -4,7 +4,9 @@ This driver follows the usual GPIO bindings found in
>  Documentation/devicetree/bindings/gpio/gpio.txt
>  
>  Required properties:
> -- compatible: Should be "x-powers,axp209-gpio"
> +- compatible: Should be one of:
> +	- "x-powers,axp209-gpio"
> +	- "x-powers,axp813-pctl"
>  - #gpio-cells: Should be two. The first cell is the pin number and the
>    second is the GPIO flags.
>  - gpio-controller: Marks the device node as a GPIO controller.
> @@ -49,8 +51,17 @@ Example:
>  GPIOs and their functions
>  -------------------------
>  
> +axp209
> +------
>  GPIO	|	Functions
>  ------------------------
>  GPIO0	|	gpio_in, gpio_out, ldo, adc
>  GPIO1	|	gpio_in, gpio_out, ldo, adc
>  GPIO2	|	gpio_in, gpio_out
> +
> +axp813
> +------
> +GPIO	|	Functions
> +------------------------
> +GPIO0	|	gpio_in, gpio_out, ldo, adc
> +GPIO1	|	gpio_in, gpio_out, ldo
> diff --git a/drivers/pinctrl/pinctrl-axp209.c b/drivers/pinctrl/pinctrl-axp209.c
> index 11f871e..500862b 100644
> --- a/drivers/pinctrl/pinctrl-axp209.c
> +++ b/drivers/pinctrl/pinctrl-axp209.c
> @@ -108,11 +108,28 @@ static const struct axp20x_desc_pin axp209_pins[] = {
>  		   AXP20X_FUNCTION(0x2, "gpio_in")),
>  };
>  
> +static const struct axp20x_desc_pin axp813_pins[] = {
> +	AXP20X_PIN(AXP20X_PINCTRL_PIN(0, "GPIO0", (void *)AXP20X_GPIO0_CTRL),
> +		   AXP20X_FUNCTION(0x0, "gpio_out"),
> +		   AXP20X_FUNCTION(0x2, "gpio_in"),
> +		   AXP20X_FUNCTION(0x3, "ldo"),
> +		   AXP20X_FUNCTION(0x4, "adc")),
> +	AXP20X_PIN(AXP20X_PINCTRL_PIN(1, "GPIO1", (void *)AXP20X_GPIO1_CTRL),
> +		   AXP20X_FUNCTION(0x0, "gpio_out"),
> +		   AXP20X_FUNCTION(0x2, "gpio_in"),
> +		   AXP20X_FUNCTION(0x3, "ldo")),
> +};
> +
>  static const struct axp20x_pinctrl_desc axp20x_pinctrl_data = {
>  	.pins	= axp209_pins,
>  	.npins	= ARRAY_SIZE(axp209_pins),
>  };
>  
> +static const struct axp20x_pinctrl_desc axp813_pinctrl_data = {
> +	.pins	= axp813_pins,
> +	.npins	= ARRAY_SIZE(axp813_pins),
> +};
> +
>  static int axp20x_gpio_input(struct gpio_chip *chip, unsigned offset)
>  {
>  	return pinctrl_gpio_direction_input(chip->base + offset);
> @@ -479,6 +496,7 @@ static int axp20x_pctl_probe(struct platform_device *pdev)
>  	struct axp20x_pctl *pctl;
>  	struct pinctrl_desc *pctrl_desc;
>  	struct pinctrl_pin_desc *pins;
> +	struct device_node *np = pdev->dev.of_node;
>  	int ret, i;
>  
>  	if (!of_device_is_available(pdev->dev.of_node))
> @@ -505,13 +523,18 @@ static int axp20x_pctl_probe(struct platform_device *pdev)
>  	pctl->chip.set			= axp20x_gpio_set;
>  	pctl->chip.direction_input	= axp20x_gpio_input;
>  	pctl->chip.direction_output	= axp20x_gpio_output;
> -	pctl->chip.ngpio		= 3;
>  
>  	pctl->regmap = axp20x->regmap;
>  
> -	pctl->desc = &axp20x_pinctrl_data;
> -	pctl->gpio_status_offset = 4;
> +	if (of_device_is_compatible(np, "x-powers,axp209-gpio")) {
> +		pctl->desc = &axp20x_pinctrl_data;
> +		pctl->gpio_status_offset = 4;
> +	} else {
> +		pctl->desc = &axp813_pinctrl_data;
> +		pctl->gpio_status_offset = 0;
> +	}
>  	pctl->dev = &pdev->dev;
> +	pctl->chip.ngpio = pctl->desc->npins;

This should be part of a structure that would be attached to the
compatible.

Thanks!
Maxime
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
index a5bfe87..a1d5dec 100644
--- a/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
+++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-axp209.txt
@@ -4,7 +4,9 @@  This driver follows the usual GPIO bindings found in
 Documentation/devicetree/bindings/gpio/gpio.txt
 
 Required properties:
-- compatible: Should be "x-powers,axp209-gpio"
+- compatible: Should be one of:
+	- "x-powers,axp209-gpio"
+	- "x-powers,axp813-pctl"
 - #gpio-cells: Should be two. The first cell is the pin number and the
   second is the GPIO flags.
 - gpio-controller: Marks the device node as a GPIO controller.
@@ -49,8 +51,17 @@  Example:
 GPIOs and their functions
 -------------------------
 
+axp209
+------
 GPIO	|	Functions
 ------------------------
 GPIO0	|	gpio_in, gpio_out, ldo, adc
 GPIO1	|	gpio_in, gpio_out, ldo, adc
 GPIO2	|	gpio_in, gpio_out
+
+axp813
+------
+GPIO	|	Functions
+------------------------
+GPIO0	|	gpio_in, gpio_out, ldo, adc
+GPIO1	|	gpio_in, gpio_out, ldo
diff --git a/drivers/pinctrl/pinctrl-axp209.c b/drivers/pinctrl/pinctrl-axp209.c
index 11f871e..500862b 100644
--- a/drivers/pinctrl/pinctrl-axp209.c
+++ b/drivers/pinctrl/pinctrl-axp209.c
@@ -108,11 +108,28 @@  static const struct axp20x_desc_pin axp209_pins[] = {
 		   AXP20X_FUNCTION(0x2, "gpio_in")),
 };
 
+static const struct axp20x_desc_pin axp813_pins[] = {
+	AXP20X_PIN(AXP20X_PINCTRL_PIN(0, "GPIO0", (void *)AXP20X_GPIO0_CTRL),
+		   AXP20X_FUNCTION(0x0, "gpio_out"),
+		   AXP20X_FUNCTION(0x2, "gpio_in"),
+		   AXP20X_FUNCTION(0x3, "ldo"),
+		   AXP20X_FUNCTION(0x4, "adc")),
+	AXP20X_PIN(AXP20X_PINCTRL_PIN(1, "GPIO1", (void *)AXP20X_GPIO1_CTRL),
+		   AXP20X_FUNCTION(0x0, "gpio_out"),
+		   AXP20X_FUNCTION(0x2, "gpio_in"),
+		   AXP20X_FUNCTION(0x3, "ldo")),
+};
+
 static const struct axp20x_pinctrl_desc axp20x_pinctrl_data = {
 	.pins	= axp209_pins,
 	.npins	= ARRAY_SIZE(axp209_pins),
 };
 
+static const struct axp20x_pinctrl_desc axp813_pinctrl_data = {
+	.pins	= axp813_pins,
+	.npins	= ARRAY_SIZE(axp813_pins),
+};
+
 static int axp20x_gpio_input(struct gpio_chip *chip, unsigned offset)
 {
 	return pinctrl_gpio_direction_input(chip->base + offset);
@@ -479,6 +496,7 @@  static int axp20x_pctl_probe(struct platform_device *pdev)
 	struct axp20x_pctl *pctl;
 	struct pinctrl_desc *pctrl_desc;
 	struct pinctrl_pin_desc *pins;
+	struct device_node *np = pdev->dev.of_node;
 	int ret, i;
 
 	if (!of_device_is_available(pdev->dev.of_node))
@@ -505,13 +523,18 @@  static int axp20x_pctl_probe(struct platform_device *pdev)
 	pctl->chip.set			= axp20x_gpio_set;
 	pctl->chip.direction_input	= axp20x_gpio_input;
 	pctl->chip.direction_output	= axp20x_gpio_output;
-	pctl->chip.ngpio		= 3;
 
 	pctl->regmap = axp20x->regmap;
 
-	pctl->desc = &axp20x_pinctrl_data;
-	pctl->gpio_status_offset = 4;
+	if (of_device_is_compatible(np, "x-powers,axp209-gpio")) {
+		pctl->desc = &axp20x_pinctrl_data;
+		pctl->gpio_status_offset = 4;
+	} else {
+		pctl->desc = &axp813_pinctrl_data;
+		pctl->gpio_status_offset = 0;
+	}
 	pctl->dev = &pdev->dev;
+	pctl->chip.ngpio = pctl->desc->npins;
 
 	platform_set_drvdata(pdev, pctl);
 
@@ -566,6 +589,7 @@  static int axp20x_pctl_probe(struct platform_device *pdev)
 
 static const struct of_device_id axp20x_pctl_match[] = {
 	{ .compatible = "x-powers,axp209-gpio" },
+	{ .compatible = "x-powers,axp813-pctl" },
 	{ }
 };
 MODULE_DEVICE_TABLE(of, axp20x_pctl_match);