Message ID | e24c7d64dbce490fbeaa0f44b56027d0@rwthex-s1-b.rwth-ad.de (mailing list archive) |
---|---|
State | New, archived |
Headers | show |
On Mon, Jun 13, 2016 at 01:24:55AM +0200, christopher.spinrath@rwth-aachen.de wrote: > From: Valentin Raevsky <valentin@compulab.co.il> > > The current ldo settings of the cm-fx6 do not allow 1.2GHz cpu > frequency. At this frequency the module behaves unstable. > > But the imx6q fuse indicates that 1.2GHz operation is possible. > Hence, remove the 1.2GHz operation point in the device tree. > > Signed-off-by: Valentin Raevsky <valentin@compulab.co.il> > [christopher.spinrath@rwth-aachen.de: enhance commit message, adjust > remaining operation points to match the ones in imx6q.dtsi and add > a comment in the device tree] > Signed-off-by: Christopher Spinrath <christopher.spinrath@rwth-aachen.de> > Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com> Applied, thanks.
diff --git a/arch/arm/boot/dts/imx6q-cm-fx6.dts b/arch/arm/boot/dts/imx6q-cm-fx6.dts index 6d8d5e9..b5de7e6 100644 --- a/arch/arm/boot/dts/imx6q-cm-fx6.dts +++ b/arch/arm/boot/dts/imx6q-cm-fx6.dts @@ -91,6 +91,28 @@ }; }; +&cpu0 { + /* + * Although the imx6q fuse indicates that 1.2GHz operation is possible, + * the module behaves unstable at this frequency. Hence, remove the + * 1.2GHz operation point here. + */ + operating-points = < + /* kHz uV */ + 996000 1250000 + 852000 1250000 + 792000 1175000 + 396000 975000 + >; + fsl,soc-operating-points = < + /* ARM kHz SOC-PU uV */ + 996000 1250000 + 852000 1250000 + 792000 1175000 + 396000 1175000 + >; +}; + &ecspi1 { fsl,spi-num-chipselects = <2>; cs-gpios = <&gpio2 30 GPIO_ACTIVE_HIGH>, <&gpio3 19 GPIO_ACTIVE_HIGH>;