@@ -71,7 +71,31 @@
interrupts = <0 7 4>;
interrupt-parent = <&intc>;
clocks = <&clkc 12>;
- };
+ };
+
+ can0: can@e0008000 {
+ compatible = "xlnx,zynq-can-1.0";
+ status = "disabled";
+ clocks = <&clkc 19>, <&clkc 36>;
+ clock-names = "can_clk", "pclk";
+ reg = <0xe0008000 0x1000>;
+ interrupts = <0 28 4>;
+ interrupt-parent = <&intc>;
+ tx-fifo-depth = <0x40>;
+ rx-fifo-depth = <0x40>;
+ };
+
+ can1: can@e0009000 {
+ compatible = "xlnx,zynq-can-1.0";
+ status = "disabled";
+ clocks = <&clkc 20>, <&clkc 37>;
+ clock-names = "can_clk", "pclk";
+ reg = <0xe0009000 0x1000>;
+ interrupts = <0 51 4>;
+ interrupt-parent = <&intc>;
+ tx-fifo-depth = <0x40>;
+ rx-fifo-depth = <0x40>;
+ };
gpio0: gpio@e000a000 {
compatible = "xlnx,zynq-gpio-1.0";
@@ -29,6 +29,10 @@
};
+&can0 {
+ status = "okay";
+};
+
&gem0 {
status = "okay";
phy-mode = "rgmii";
Add node describing Zynq's CAN controller. Signed-off-by: Michal Simek <michal.simek@xilinx.com> --- Changes in v3: - Fix clocks description for can1 Changes in v2: - Add can1 - Enable can0 for zc702 - Use status property arch/arm/boot/dts/zynq-7000.dtsi | 26 +++++++++++++++++++++++++- arch/arm/boot/dts/zynq-zc702.dts | 4 ++++ 2 files changed, 29 insertions(+), 1 deletion(-) -- 1.8.2.3