diff mbox series

arm64: dts: rockchip: Fix Pinebook Pro FUSB302 interrupt

Message ID f731122c5ccde4e3d6d149a9d7bf01708b4279f7.1587736459.git.robin.murphy@arm.com (mailing list archive)
State Mainlined
Commit 89ee3ace7292d94539aae156fb6fee65460b8bc0
Headers show
Series arm64: dts: rockchip: Fix Pinebook Pro FUSB302 interrupt | expand

Commit Message

Robin Murphy April 24, 2020, 1:56 p.m. UTC
Although the FUSB302 driver has apparently supported the "fcs,int_n"
property since the beginning, the DT binding has never documented it,
and in fact defines a standard "interrupts" property as required. It's
also questionable whether the GPIO specifier with GPIO_ACTIVE_HIGH is
even correct, since the FUSB302 datasheet says INT_N is an "Active-LOW
open-drain interrupt output", and the Pinebook Pro schematic shows it
wired directly to the GPIO pin.

Just use the standard property like all the other RK3399 boards sharing
the same design.

Signed-off-by: Robin Murphy <robin.murphy@arm.com>
---
 arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

Comments

Heiko Stuebner April 27, 2020, 7:42 p.m. UTC | #1
On Fri, 24 Apr 2020 14:56:19 +0100, Robin Murphy wrote:
> Although the FUSB302 driver has apparently supported the "fcs,int_n"
> property since the beginning, the DT binding has never documented it,
> and in fact defines a standard "interrupts" property as required. It's
> also questionable whether the GPIO specifier with GPIO_ACTIVE_HIGH is
> even correct, since the FUSB302 datasheet says INT_N is an "Active-LOW
> open-drain interrupt output", and the Pinebook Pro schematic shows it
> wired directly to the GPIO pin.
> 
> [...]

Applied, thanks!

[1/1] arm64: dts: rockchip: Fix Pinebook Pro FUSB302 interrupt
      commit: 89ee3ace7292d94539aae156fb6fee65460b8bc0

Best regards,
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts b/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
index 5ea281b55fe2..1417c3b2d163 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts
@@ -690,7 +690,8 @@ 
 	fusb0: fusb30x@22 {
 		compatible = "fcs,fusb302";
 		reg = <0x22>;
-		fcs,int_n = <&gpio1 RK_PA2 GPIO_ACTIVE_HIGH>;
+		interrupt-parent = <&gpio1>;
+		interrupts = <RK_PA2 IRQ_TYPE_LEVEL_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&fusb0_int_gpio>;
 		vbus-supply = <&vbus_typec>;