| Message ID | tencent_CCC29C4F562F2DEFE48289DB52F4D91BDE05@qq.com (mailing list archive) |
|---|---|
| State | New |
| Headers | show |
| Series | [v1] net: stmmac: enable MAC after MTL configuring | expand |
On Mon, 21 Oct 2024 09:03:05 +0800, 2694439648@qq.com wrote: > From: "hailong.fan" <hailong.fan@siengine.com> > > DMA maybe block while ETH is opening, > Adjust the enable sequence, put the MAC enable last > > For example, ETH is directly connected to the switch, > which never power down and sends broadcast packets at regular intervals. > During the process of opening ETH, data may flow into the MTL FIFO, > once MAC RX is enabled. and then, MTL will be set, such as FIFO size. > Once enable DMA, There is a certain probability that DMA will read > incorrect data from MTL FIFO, causing DMA to hang up. > By read DMA_Debug_Status, you can be observed that the RPS remains at > a certain value forever. The correct process should be to configure > MAC/MTL/DMA before enabling DMA/MAC > > Signed-off-by: hailong.fan <hailong.fan@siengine.com> > A Fixes: tag should be added. > static void dwxgmac2_dma_stop_rx(struct stmmac_priv *priv, void __iomem *ioaddr, > diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > index e21404822..c19ca62a4 100644 > --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c > @@ -3437,9 +3437,6 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) > priv->hw->rx_csum = 0; > } > > - /* Enable the MAC Rx/Tx */ > - stmmac_mac_set(priv, priv->ioaddr, true); > - > /* Set the HW DMA mode and the COE */ > stmmac_dma_operation_mode(priv); > > @@ -3523,6 +3520,9 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) > /* Start the ball rolling... */ > stmmac_start_all_dma(priv); > > + /* Enable the MAC Rx/Tx */ > + stmmac_mac_set(priv, priv->ioaddr, true); > + This sequence fix should be applied to stmmac_xdp_open() too. > stmmac_set_hw_vlan_mode(priv, priv->hw); > > return 0; It is better to split this patch into individual patches, since you are trying to fix an issue related to several previous commits: dwmac4, dwxgmac2, stmmac_hw_setup() and stmmac_xdp_open()
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac4_lib.c b/drivers/net/ethernet/stmicro/stmmac/dwmac4_lib.c index 0d185e54e..92448d858 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwmac4_lib.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac4_lib.c @@ -50,10 +50,6 @@ void dwmac4_dma_start_tx(struct stmmac_priv *priv, void __iomem *ioaddr, value |= DMA_CONTROL_ST; writel(value, ioaddr + DMA_CHAN_TX_CONTROL(dwmac4_addrs, chan)); - - value = readl(ioaddr + GMAC_CONFIG); - value |= GMAC_CONFIG_TE; - writel(value, ioaddr + GMAC_CONFIG); } void dwmac4_dma_stop_tx(struct stmmac_priv *priv, void __iomem *ioaddr, @@ -77,10 +73,6 @@ void dwmac4_dma_start_rx(struct stmmac_priv *priv, void __iomem *ioaddr, value |= DMA_CONTROL_SR; writel(value, ioaddr + DMA_CHAN_RX_CONTROL(dwmac4_addrs, chan)); - - value = readl(ioaddr + GMAC_CONFIG); - value |= GMAC_CONFIG_RE; - writel(value, ioaddr + GMAC_CONFIG); } void dwmac4_dma_stop_rx(struct stmmac_priv *priv, void __iomem *ioaddr, diff --git a/drivers/net/ethernet/stmicro/stmmac/dwxgmac2_dma.c b/drivers/net/ethernet/stmicro/stmmac/dwxgmac2_dma.c index 7840bc403..cba12edc1 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwxgmac2_dma.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwxgmac2_dma.c @@ -288,10 +288,6 @@ static void dwxgmac2_dma_start_tx(struct stmmac_priv *priv, value = readl(ioaddr + XGMAC_DMA_CH_TX_CONTROL(chan)); value |= XGMAC_TXST; writel(value, ioaddr + XGMAC_DMA_CH_TX_CONTROL(chan)); - - value = readl(ioaddr + XGMAC_TX_CONFIG); - value |= XGMAC_CONFIG_TE; - writel(value, ioaddr + XGMAC_TX_CONFIG); } static void dwxgmac2_dma_stop_tx(struct stmmac_priv *priv, void __iomem *ioaddr, @@ -302,10 +298,6 @@ static void dwxgmac2_dma_stop_tx(struct stmmac_priv *priv, void __iomem *ioaddr, value = readl(ioaddr + XGMAC_DMA_CH_TX_CONTROL(chan)); value &= ~XGMAC_TXST; writel(value, ioaddr + XGMAC_DMA_CH_TX_CONTROL(chan)); - - value = readl(ioaddr + XGMAC_TX_CONFIG); - value &= ~XGMAC_CONFIG_TE; - writel(value, ioaddr + XGMAC_TX_CONFIG); } static void dwxgmac2_dma_start_rx(struct stmmac_priv *priv, @@ -316,10 +308,6 @@ static void dwxgmac2_dma_start_rx(struct stmmac_priv *priv, value = readl(ioaddr + XGMAC_DMA_CH_RX_CONTROL(chan)); value |= XGMAC_RXST; writel(value, ioaddr + XGMAC_DMA_CH_RX_CONTROL(chan)); - - value = readl(ioaddr + XGMAC_RX_CONFIG); - value |= XGMAC_CONFIG_RE; - writel(value, ioaddr + XGMAC_RX_CONFIG); } static void dwxgmac2_dma_stop_rx(struct stmmac_priv *priv, void __iomem *ioaddr, diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index e21404822..c19ca62a4 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -3437,9 +3437,6 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) priv->hw->rx_csum = 0; } - /* Enable the MAC Rx/Tx */ - stmmac_mac_set(priv, priv->ioaddr, true); - /* Set the HW DMA mode and the COE */ stmmac_dma_operation_mode(priv); @@ -3523,6 +3520,9 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register) /* Start the ball rolling... */ stmmac_start_all_dma(priv); + /* Enable the MAC Rx/Tx */ + stmmac_mac_set(priv, priv->ioaddr, true); + stmmac_set_hw_vlan_mode(priv, priv->hw); return 0;