diff mbox

[1/3] gliolib: request the gpio before querying its direction

Message ID 1500335041-32711-2-git-send-email-timur@codeaurora.org (mailing list archive)
State Not Applicable, archived
Delegated to: Andy Gross
Headers show

Commit Message

Timur Tabi July 17, 2017, 11:43 p.m. UTC 
Before querying a GPIO to determine its direction, the GPIO should be
formally requested.  This allows the GPIO driver to block access to
unavailable GPIOs, which makes it easier for some drivers to support
sparse GPIO maps.

Signed-off-by: Timur Tabi <timur@codeaurora.org>
---
 drivers/gpio/gpiolib.c | 11 +++++++++++
 1 file changed, 11 insertions(+)
diff mbox

Patch

diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index 9568708..3b4e1e8 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -1202,6 +1202,14 @@  int gpiochip_add_data(struct gpio_chip *chip, void *data)
 		struct gpio_desc *desc = &gdev->descs[i];
 
 		desc->gdev = gdev;
+
+		if (chip->request) {
+			status = chip->request(chip, i);
+			if (status < 0)
+				/* The GPIO is unavailable, so skip it */
+				continue;
+		}
+
 		/*
 		 * REVISIT: most hardware initializes GPIOs as inputs
 		 * (often with pullups enabled) so power usage is
@@ -1227,6 +1235,9 @@  int gpiochip_add_data(struct gpio_chip *chip, void *data)
 			 */
 			set_bit(FLAG_IS_OUT, &desc->flags);
 		}
+
+		if (chip->free)
+			chip->free(chip, i);
 	}
 
 #ifdef CONFIG_PINCTRL