Message ID | 1590560864-27037-4-git-send-email-akashast@codeaurora.org (mailing list archive) |
---|---|
State | New, archived |
Headers | show |
Series | Convert QUP bindings to YAML and add ICC, pin swap doc | expand |
On Wed, 27 May 2020 11:57:44 +0530, Akash Asthana wrote: > Add documentation to support RX-TX & CTS-RTS GPIO pin swap in HW. > > Signed-off-by: Akash Asthana <akashast@codeaurora.org> > Reviewed-by: Stephen Boyd <swboyd@chromium.org> > --- > Changes in V7: > - As per Rob's comment, added type: boolean to properties. > > Documentation/devicetree/bindings/serial/serial.yaml | 8 ++++++++ > 1 file changed, 8 insertions(+) > Applied, thanks!
diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml index 53204d9..8645d0e 100644 --- a/Documentation/devicetree/bindings/serial/serial.yaml +++ b/Documentation/devicetree/bindings/serial/serial.yaml @@ -67,6 +67,14 @@ properties: (wired and enabled by pinmux configuration). This depends on both the UART hardware and the board wiring. + rx-tx-swap: + type: boolean + description: RX and TX pins are swapped. + + cts-rts-swap: + type: boolean + description: CTS and RTS pins are swapped. + if: required: - uart-has-rtscts