@@ -216,6 +216,7 @@
#define SPI_HOLD (1 << 27)
#define SPI_TRANSFER_MODE_x1 (1 << 29)
#define SPI_TRANSFER_MODE_x4 (3 << 29)
+#define QPIC_v2_0 0x2
#define nandc_set_read_loc(nandc, reg, offset, size, is_last) \
nandc_set_reg(nandc, NAND_READ_LOCATION_##reg, \
@@ -223,6 +224,12 @@ nandc_set_reg(nandc, NAND_READ_LOCATION_##reg, \
((size) << READ_LOCATION_SIZE) | \
((is_last) << READ_LOCATION_LAST))
+#define nandc_set_read_loc_last(nandc, reg, offset, size, is_last) \
+nandc_set_reg(nandc, NAND_READ_LOCATION_LAST_CW_##reg, \
+ ((offset) << READ_LOCATION_OFFSET) | \
+ ((size) << READ_LOCATION_SIZE) | \
+ ((is_last) << READ_LOCATION_LAST))
+
/*
* Returns the actual register address for all NAND_DEV_ registers
* (i.e. NAND_DEV_CMD0, NAND_DEV_CMD1, NAND_DEV_CMD2 and NAND_DEV_CMD_VLD)
@@ -352,6 +359,10 @@ struct nandc_regs {
__le32 read_location1;
__le32 read_location2;
__le32 read_location3;
+ __le32 read_location_last0;
+ __le32 read_location_last1;
+ __le32 read_location_last2;
+ __le32 read_location_last3;
__le32 spi_cfg;
__le32 num_addr_cycle;
__le32 busy_wait_cnt;
@@ -685,6 +696,14 @@ static __le32 *offset_to_nandc_reg(struct nandc_regs *regs, int offset)
return ®s->read_location2;
case NAND_READ_LOCATION_3:
return ®s->read_location3;
+ case NAND_READ_LOCATION_LAST_CW_0:
+ return ®s->read_location_last0;
+ case NAND_READ_LOCATION_LAST_CW_1:
+ return ®s->read_location_last1;
+ case NAND_READ_LOCATION_LAST_CW_2:
+ return ®s->read_location_last2;
+ case NAND_READ_LOCATION_LAST_CW_3:
+ return ®s->read_location_last3;
case NAND_FLASH_SPI_CFG:
return ®s->spi_cfg;
case NAND_SPI_NUM_ADDR_CYCLES:
@@ -734,13 +753,18 @@ static void update_rw_regs(struct qcom_nand_host *host, int num_cw, bool read)
struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
u32 cmd, cfg0, cfg1, ecc_bch_cfg;
+ cmd = (PAGE_ACC | LAST_PAGE);
+
+ if (nandc->props->is_serial_nand)
+ cmd |= (SPI_TRANSFER_MODE_x1 | SPI_WP | SPI_HOLD);
+
if (read) {
if (host->use_ecc)
- cmd = OP_PAGE_READ_WITH_ECC | PAGE_ACC | LAST_PAGE;
+ cmd |= OP_PAGE_READ_WITH_ECC;
else
- cmd = OP_PAGE_READ | PAGE_ACC | LAST_PAGE;
+ cmd |= OP_PAGE_READ;
} else {
- cmd = OP_PROGRAM_PAGE | PAGE_ACC | LAST_PAGE;
+ cmd |= OP_PROGRAM_PAGE;
}
if (host->use_ecc) {
@@ -766,9 +790,14 @@ static void update_rw_regs(struct qcom_nand_host *host, int num_cw, bool read)
nandc_set_reg(nandc, NAND_READ_STATUS, host->clrreadstatus);
nandc_set_reg(nandc, NAND_EXEC_CMD, 1);
- if (read)
+ if (read) {
+ if (nandc->hw_version >= QPIC_v2_0)
+ nandc_set_read_loc_last(nandc, 0, 0, host->use_ecc ?
+ host->cw_data : host->cw_size, 1);
+
nandc_set_read_loc(nandc, 0, 0, host->use_ecc ?
host->cw_data : host->cw_size, 1);
+ }
}
/*
@@ -1143,9 +1172,13 @@ static void config_nand_page_read(struct qcom_nand_controller *nandc)
static void
config_nand_cw_read(struct qcom_nand_controller *nandc, bool use_ecc)
{
- if (nandc->props->is_bam)
+ if (nandc->props->is_bam) {
+ if (nandc->hw_version >= QPIC_v2_0)
+ write_reg_dma(nandc, NAND_READ_LOCATION_LAST_CW_0,
+ 4, NAND_BAM_NEXT_SGL);
write_reg_dma(nandc, NAND_READ_LOCATION_0, 4,
NAND_BAM_NEXT_SGL);
+ }
write_reg_dma(nandc, NAND_FLASH_CMD, 1, NAND_BAM_NEXT_SGL);
write_reg_dma(nandc, NAND_EXEC_CMD, 1, NAND_BAM_NEXT_SGL);
@@ -1266,9 +1299,13 @@ static int erase_block(struct qcom_nand_host *host, int page_addr)
{
struct nand_chip *chip = &host->chip;
struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+ u32 ers_cmd = OP_BLOCK_ERASE | PAGE_ACC | LAST_PAGE;
- nandc_set_reg(nandc, NAND_FLASH_CMD,
- OP_BLOCK_ERASE | PAGE_ACC | LAST_PAGE);
+ if (nandc->props->is_serial_nand) {
+ ers_cmd |= (SPI_WP | SPI_HOLD | SPI_TRANSFER_MODE_x1);
+ page_addr <<= 16;
+ }
+ nandc_set_reg(nandc, NAND_FLASH_CMD, ers_cmd);
nandc_set_reg(nandc, NAND_ADDR0, page_addr);
nandc_set_reg(nandc, NAND_ADDR1, 0);
nandc_set_reg(nandc, NAND_DEV0_CFG0,
@@ -1680,16 +1717,32 @@ qcom_nandc_read_cw_raw(struct mtd_info *mtd, struct nand_chip *chip,
}
if (nandc->props->is_bam) {
- nandc_set_read_loc(nandc, 0, read_loc, data_size1, 0);
+ if ((nandc->hw_version >= QPIC_v2_0) &&
+ (cw == (ecc->steps - 1)))
+ nandc_set_read_loc_last(nandc, 0, read_loc, data_size1, 0);
+ else
+ nandc_set_read_loc(nandc, 0, read_loc, data_size1, 0);
read_loc += data_size1;
- nandc_set_read_loc(nandc, 1, read_loc, oob_size1, 0);
+ if ((nandc->hw_version >= QPIC_v2_0) &&
+ (cw == (ecc->steps - 1)))
+ nandc_set_read_loc_last(nandc, 1, read_loc, oob_size1, 0);
+ else
+ nandc_set_read_loc(nandc, 1, read_loc, oob_size1, 0);
read_loc += oob_size1;
- nandc_set_read_loc(nandc, 2, read_loc, data_size2, 0);
+ if ((nandc->hw_version >= QPIC_v2_0) &&
+ (cw == (ecc->steps - 1)))
+ nandc_set_read_loc_last(nandc, 2, read_loc, data_size2, 0);
+ else
+ nandc_set_read_loc(nandc, 2, read_loc, data_size2, 0);
read_loc += data_size2;
- nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
+ if ((nandc->hw_version >= QPIC_v2_0) &&
+ (cw == (ecc->steps - 1)))
+ nandc_set_read_loc_last(nandc, 3, read_loc, oob_size2, 0);
+ else
+ nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
}
config_nand_cw_read(nandc, false);
@@ -1924,10 +1977,26 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
nandc_set_read_loc(nandc, 1, data_size,
oob_size, 1);
} else if (data_buf) {
- nandc_set_read_loc(nandc, 0, 0, data_size, 1);
+ if (nandc->hw_version >= QPIC_v2_0) {
+ if (i == (ecc->steps - 1))
+ nandc_set_read_loc_last(nandc, 0, 0,
+ data_size, 1);
+ else
+ nandc_set_read_loc(nandc, 0, 0,
+ data_size, 1);
+ } else
+ nandc_set_read_loc(nandc, 0, 0, data_size, 1);
} else {
- nandc_set_read_loc(nandc, 0, data_size,
- oob_size, 1);
+ if (nandc->hw_version >= QPIC_v2_0) {
+ if (i == (ecc->steps - 1))
+ nandc_set_read_loc_last(nandc, 0, data_size,
+ oob_size, 1);
+ else
+ nandc_set_read_loc(nandc, 0, data_size,
+ oob_size, 1);
+ } else
+ nandc_set_read_loc(nandc, 0, data_size,
+ oob_size, 1);
}
}
This change will enable support for erase , read & write support for QSPI serial nand. In QPIC V2.0 onwards, to read last code word new regiater is introduced. So to read for first three code word we have to use LOCATION_n register and for last code word we ahve to use LAST_CW_n. Signed-off-by: Md Sadre Alam <mdalam@codeaurora.org> --- drivers/mtd/nand/raw/qcom_nandc.c | 97 +++++++++++++++++++++++++++++++++------ 1 file changed, 83 insertions(+), 14 deletions(-)