@@ -263,6 +263,65 @@
};
};
+pm8008_bus: &i2c1 {
+ status = "okay";
+};
+
+#include "pm8008.dtsi"
+
+&pm8008 {
+ interrupt-parent = <&tlmm>;
+ interrupts = <24 IRQ_TYPE_EDGE_RISING>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&pm8008_active>;
+
+ reset-gpios = <&pm8350c_gpios 4 GPIO_ACTIVE_HIGH>;
+};
+
+&pm8008_regulators {
+ vdd_l1_l2-supply = <&vreg_s8b_1p2>;
+ vdd_l3_l4-supply = <&vreg_s1b_1p8>;
+ vdd_l5-supply = <&vreg_bob>;
+ vdd_l6-supply = <&vreg_bob>;
+ vdd_l7-supply = <&vreg_bob>;
+};
+
+&pm8008_l1 {
+ regulator-min-microvolt = <950000>;
+ regulator-max-microvolt = <1300000>;
+};
+
+&pm8008_l2 {
+ regulator-min-microvolt = <950000>;
+ regulator-max-microvolt = <1250000>;
+};
+
+&pm8008_l3 {
+ regulator-min-microvolt = <1650000>;
+ regulator-max-microvolt = <3000000>;
+};
+
+&pm8008_l4 {
+ regulator-min-microvolt = <1504000>;
+ regulator-max-microvolt = <1600000>;
+};
+
+&pm8008_l5 {
+ regulator-min-microvolt = <2600000>;
+ regulator-max-microvolt = <3000000>;
+};
+
+&pm8008_l6 {
+ regulator-min-microvolt = <2600000>;
+ regulator-max-microvolt = <3000000>;
+};
+
+&pm8008_l7 {
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3544000>;
+};
+
&qfprom {
vcc-supply = <&vreg_l1c_1p8>;
};
@@ -375,6 +434,15 @@
drive-strength = <2>;
};
+&pm8350c_gpios {
+ pm8008_active: pm8008-active {
+ pins = "gpio4";
+ function = "normal";
+ bias-disable;
+ power-source = <0>;
+ };
+};
+
&qspi_cs0 {
bias-disable;
};
Add pm8008 infra and regulators support for sc7280 idp. Signed-off-by: Satya Priya <quic_c_skakit@quicinc.com> --- Changes in V6: - No changes. Changes in V7: - No Changes. Changes in V8: - Add an extra phandle "pm8008_bus" and then include pm8008 dtsi files inside it. - Remove output-high from pm8008_active node. Changes in V9: - Added interrupts properties. arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 68 ++++++++++++++++++++++++++++++++ 1 file changed, 68 insertions(+)