diff mbox series

[V6,2/2] arm64: dts: qcom: sc7280-qcard: Configure CTS pin to bias-bus-hold for bluetooth

Message ID 1650556567-4995-3-git-send-email-quic_vnivarth@quicinc.com (mailing list archive)
State Accepted
Headers show
Series arm64: dts: qcom: Configure CTS pin to bias-bus-hold for bluetooth | expand

Commit Message

Vijaya Krishna Nivarthi April 21, 2022, 3:56 p.m. UTC 
WLAN rail was leaking power during RBSC/sleep even after turning BT off.
Change active and sleep pinctrl configurations to handle same.

Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@quicinc.com>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
---
v6: add code comments about how bias-bus-hold could save power
v5: modify subject to include bluetooth
v4: modify subject of patch to indicate file it is applying to
v3: apply same change to active state and other sc7280*.dts* as well
v2: used bias-bus-hold as per review comments
v1: intial patch used bias-disable for sleep pinctrl in sc7280-idp only
---
 arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi | 19 ++++++++++++++-----
 1 file changed, 14 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
index b833ba1..98b5cd70 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
@@ -398,8 +398,14 @@  mos_bt_uart: &uart7 {
 
 /* For mos_bt_uart */
 &qup_uart7_cts {
-	/* Configure a pull-down on CTS to match the pull of the Bluetooth module. */
-	bias-pull-down;
+	/*
+	 * Configure a bias-bus-hold on CTS to lower power
+	 * usage when Bluetooth is turned off. Bus hold will
+	 * maintain a low power state regardless of whether
+	 * the Bluetooth module drives the pin in either
+	 * direction or leaves the pin fully unpowered.
+	 */
+	bias-bus-hold;
 };
 
 /* For mos_bt_uart */
@@ -490,10 +496,13 @@  mos_bt_uart: &uart7 {
 		pins = "gpio28";
 		function = "gpio";
 		/*
-		 * Configure a pull-down on CTS to match the pull of
-		 * the Bluetooth module.
+		 * Configure a bias-bus-hold on CTS to lower power
+		 * usage when Bluetooth is turned off. Bus hold will
+		 * maintain a low power state regardless of whether
+		 * the Bluetooth module drives the pin in either
+		 * direction or leaves the pin fully unpowered.
 		 */
-		bias-pull-down;
+		bias-bus-hold;
 	};
 
 	/* For mos_bt_uart */