tty: serial: qcom-geni-serial: Poll primary sequencer irq status after cancel_tx

Commit Message

Vijaya Krishna Nivarthi Aug. 9, 2023, 10:53 a.m. UTC

TX is handled by primary sequencer. After cancelling primary command, poll
primary sequencer's irq status instead of that of secondary.
While at it, also remove a couple of redundant lines that read from IRQ_EN
register and write back same.

Fixes: 2aaa43c70778 ("tty: serial: qcom-geni-serial: add support for serial engine DMA")
Signed-off-by: Vijaya Krishna Nivarthi <[e-mail]>
---
 drivers/tty/serial/qcom_geni_serial.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

Patch

diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 3ca5db2..b8aa4c1 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -591,7 +591,6 @@  static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
 {
 	struct qcom_geni_serial_port *port = to_dev_port(uport);
 	bool done;
-	u32 m_irq_en;
 
 	if (!qcom_geni_serial_main_active(uport))
 		return;
@@ -603,12 +602,10 @@  static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
 		port->tx_remaining = 0;
 	}
 
-	m_irq_en = readl(uport->membase + SE_GENI_M_IRQ_EN);
-	writel(m_irq_en, uport->membase + SE_GENI_M_IRQ_EN);
 	geni_se_cancel_m_cmd(&port->se);
 
-	done = qcom_geni_serial_poll_bit(uport, SE_GENI_S_IRQ_STATUS,
-					 S_CMD_CANCEL_EN, true);
+	done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,
+					 M_CMD_CANCEL_EN, true);
 	if (!done) {
 		geni_se_abort_m_cmd(&port->se);
 		done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,