@@ -2137,6 +2137,13 @@ void msm_dsi_host_get_phy_clk_req(struct mipi_dsi_host *host,
struct msm_dsi_phy_clk_request *clk_req)
{
struct msm_dsi_host *msm_host = to_msm_dsi_host(host);
+ int ret;
+
+ ret = dsi_calc_clk_rate(msm_host);
+ if (ret) {
+ pr_err("%s: unable to calc clk rate, %d\n", __func__, ret);
+ return;
+ }
clk_req->bitclk_rate = msm_host->byte_clk_rate * 8;
clk_req->escclk_rate = msm_host->esc_clk_rate;
@@ -2280,7 +2287,6 @@ int msm_dsi_host_set_display_mode(struct mipi_dsi_host *host,
struct drm_display_mode *mode)
{
struct msm_dsi_host *msm_host = to_msm_dsi_host(host);
- int ret;
if (msm_host->mode) {
drm_mode_destroy(msm_host->dev, msm_host->mode);
@@ -2293,12 +2299,6 @@ int msm_dsi_host_set_display_mode(struct mipi_dsi_host *host,
return -ENOMEM;
}
- ret = dsi_calc_clk_rate(msm_host);
- if (ret) {
- pr_err("%s: unable to calc clk rate, %d\n", __func__, ret);
- return ret;
- }
-
return 0;
}
After the commit mentioned below, we start computing the byte and pixel clocks (dsi_calc_clk_rate) in the DSI bridge's mode_set() op. The calculation involves the number of DSI lanes being used by the downstream bridge/panel. If the downstream bridge/panel tries to change the number of DSI lanes (as done in the ADV7533 driver) in its mode_set() op, then our DSI host driver will not have the correct number of lanes when computing byte/pixel clocks. Fix this by delaying the clock rate calculation in the DSI bridge enable path. In particular, compute the clock rates in msm_dsi_host_get_phy_clk_req(). This fixes the DSI host error interrupts seen when we try to switch between modes that require different number of lanes (4 to 3 lanes, or vice versa) on db410c. The error interrupts occur since the byte/pixel clock rates aren't according to what the DSI video mode timing engine expects. Fixes: b62aa70a98c5 ("drm/msm/dsi: Move PHY operations out of host") Signed-off-by: Archit Taneja <architt@codeaurora.org> --- drivers/gpu/drm/msm/dsi/dsi_host.c | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)