diff mbox series

[v5,2/8] dt-bindings: phy-qcom-qmp: Add UFS PHY reset

Message ID 20190321171800.104681-3-evgreen@chromium.org (mailing list archive)
State Not Applicable, archived
Headers show
Series phy: qcom-ufs: Enable regulators to be off in suspend | expand

Commit Message

Evan Green March 21, 2019, 5:17 p.m. UTC 
Add a required reset to the SDM845 UFS phy to express the PHY reset
bit inside the UFS controller register space. Before this change, this
reset was not expressed in the DT, and the driver utilized two different
callbacks (phy_init and phy_poweron) to implement a two-phase
initialization procedure that involved deasserting this reset between
init and poweron. This abused the two callbacks and diluted their
purpose.

That scheme does not work as regulators cannot be turned off in
phy_poweroff because they were turned on in init, rather than poweron.
The net result is that regulators are left on in suspend that shouldn't
be.

This new scheme gives the UFS reset to the PHY, so that it can fully
initialize itself in a single callback. We can then turn regulators on
during poweron and off during poweroff.

Signed-off-by: Evan Green <evgreen@chromium.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
---

Changes in v5: None
Changes in v4: None
Changes in v3: None
Changes in v2: None

 Documentation/devicetree/bindings/phy/qcom-qmp-phy.txt | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/phy/qcom-qmp-phy.txt b/Documentation/devicetree/bindings/phy/qcom-qmp-phy.txt
index 5d181fc3cc18..4a78ba8b85bc 100644
--- a/Documentation/devicetree/bindings/phy/qcom-qmp-phy.txt
+++ b/Documentation/devicetree/bindings/phy/qcom-qmp-phy.txt
@@ -59,7 +59,8 @@  Required properties:
 	   one for each entry in reset-names.
  - reset-names: "phy" for reset of phy block,
 		"common" for phy common block reset,
-		"cfg" for phy's ahb cfg block reset.
+		"cfg" for phy's ahb cfg block reset,
+		"ufsphy" for the PHY reset in the UFS controller.
 
 		For "qcom,ipq8074-qmp-pcie-phy" must contain:
 			"phy", "common".
@@ -74,7 +75,8 @@  Required properties:
 			"phy", "common".
 		For "qcom,sdm845-qmp-usb3-uni-phy" must contain:
 			"phy", "common".
-		For "qcom,sdm845-qmp-ufs-phy": no resets are listed.
+		For "qcom,sdm845-qmp-ufs-phy": must contain:
+			"ufsphy".
 
  - vdda-phy-supply: Phandle to a regulator supply to PHY core block.
  - vdda-pll-supply: Phandle to 1.8V regulator supply to PHY refclk pll block.