@@ -1178,5 +1178,15 @@ config REGULATOR_WM8994
This driver provides support for the voltage regulators on the
WM8994 CODEC.
+config REGULATOR_QCOM_LABIBB
+ tristate "QCOM LAB/IBB regulator support"
+ depends on SPMI || COMPILE_TEST
+ help
+ This driver supports Qualcomm's LAB/IBB regulators present on the
+ Qualcomm's PMIC chip pmi8998. QCOM LAB and IBB are SPMI
+ based PMIC implementations. LAB can be used as positive
+ boost regulator and IBB can be used as a negative boost regulator
+ for LCD display panel.
+
endif
@@ -88,6 +88,7 @@ obj-$(CONFIG_REGULATOR_MT6323) += mt6323-regulator.o
obj-$(CONFIG_REGULATOR_MT6358) += mt6358-regulator.o
obj-$(CONFIG_REGULATOR_MT6380) += mt6380-regulator.o
obj-$(CONFIG_REGULATOR_MT6397) += mt6397-regulator.o
+obj-$(CONFIG_REGULATOR_QCOM_LABIBB) += qcom-labibb-regulator.o
obj-$(CONFIG_REGULATOR_QCOM_RPM) += qcom_rpm-regulator.o
obj-$(CONFIG_REGULATOR_QCOM_RPMH) += qcom-rpmh-regulator.o
obj-$(CONFIG_REGULATOR_QCOM_SMD_RPM) += qcom_smd-regulator.o
new file mode 100644
@@ -0,0 +1,175 @@
+// SPDX-License-Identifier: GPL-2.0-only
+// Copyright (c) 2020, The Linux Foundation. All rights reserved.
+
+#include <linux/module.h>
+#include <linux/of_irq.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/platform_device.h>
+#include <linux/regmap.h>
+#include <linux/regulator/driver.h>
+#include <linux/regulator/of_regulator.h>
+
+#define REG_PERPH_TYPE 0x04
+
+#define QCOM_LAB_TYPE 0x24
+#define QCOM_IBB_TYPE 0x20
+
+#define PMI8998_LAB_REG_BASE 0xde00
+#define PMI8998_IBB_REG_BASE 0xdc00
+
+#define REG_LABIBB_STATUS1 0x08
+#define REG_LABIBB_ENABLE_CTL 0x46
+#define LABIBB_STATUS1_VREG_OK_BIT BIT(7)
+#define LABIBB_CONTROL_ENABLE BIT(7)
+
+#define LAB_ENABLE_CTL_MASK BIT(7)
+#define IBB_ENABLE_CTL_MASK (BIT(7) | BIT(6))
+
+#define LABIBB_OFF_ON_DELAY 1000
+#define LAB_ENABLE_TIME (LABIBB_OFF_ON_DELAY * 2)
+#define IBB_ENABLE_TIME (LABIBB_OFF_ON_DELAY * 10)
+#define LABIBB_POLL_ENABLED_TIME 1000
+
+struct labibb_regulator {
+ struct regulator_desc desc;
+ struct device *dev;
+ struct regmap *regmap;
+ struct regulator_dev *rdev;
+ u16 base;
+ u8 type;
+};
+
+struct labibb_regulator_data {
+ const char *name;
+ u8 type;
+ u16 base;
+ struct regulator_desc *desc;
+};
+
+static struct regulator_ops qcom_labibb_ops = {
+ .enable = regulator_enable_regmap,
+ .disable = regulator_disable_regmap,
+ .is_enabled = regulator_is_enabled_regmap,
+};
+
+static struct regulator_desc pmi8998_lab_desc = {
+ .enable_mask = LAB_ENABLE_CTL_MASK,
+ .enable_reg = (PMI8998_LAB_REG_BASE + REG_LABIBB_ENABLE_CTL),
+ .enable_val = LABIBB_CONTROL_ENABLE,
+ .enable_time = LAB_ENABLE_TIME,
+ .poll_enabled_time = LABIBB_POLL_ENABLED_TIME,
+ .off_on_delay = LABIBB_OFF_ON_DELAY,
+ .owner = THIS_MODULE,
+ .type = REGULATOR_VOLTAGE,
+ .ops = &qcom_labibb_ops,
+};
+
+static struct regulator_desc pmi8998_ibb_desc = {
+ .enable_mask = IBB_ENABLE_CTL_MASK,
+ .enable_reg = (PMI8998_IBB_REG_BASE + REG_LABIBB_ENABLE_CTL),
+ .enable_val = LABIBB_CONTROL_ENABLE,
+ .enable_time = IBB_ENABLE_TIME,
+ .poll_enabled_time = LABIBB_POLL_ENABLED_TIME,
+ .off_on_delay = LABIBB_OFF_ON_DELAY,
+ .owner = THIS_MODULE,
+ .type = REGULATOR_VOLTAGE,
+ .ops = &qcom_labibb_ops,
+};
+
+static const struct labibb_regulator_data pmi8998_labibb_data[] = {
+ {"lab", QCOM_LAB_TYPE, PMI8998_LAB_REG_BASE, &pmi8998_lab_desc},
+ {"ibb", QCOM_IBB_TYPE, PMI8998_IBB_REG_BASE, &pmi8998_ibb_desc},
+ { },
+};
+
+static const struct of_device_id qcom_labibb_match[] = {
+ { .compatible = "qcom,pmi8998-lab-ibb", .data = &pmi8998_labibb_data},
+ { },
+};
+MODULE_DEVICE_TABLE(of, qcom_labibb_match);
+
+static int qcom_labibb_regulator_probe(struct platform_device *pdev)
+{
+ struct labibb_regulator *vreg;
+ struct device *dev = &pdev->dev;
+ struct regulator_config cfg = {};
+
+ const struct of_device_id *match;
+ const struct labibb_regulator_data *reg_data;
+ struct regmap *reg_regmap;
+ unsigned int type;
+ int ret;
+
+ reg_regmap = dev_get_regmap(pdev->dev.parent, NULL);
+ if (!reg_regmap) {
+ dev_err(&pdev->dev, "Couldn't get parent's regmap\n");
+ return -ENODEV;
+ }
+
+ match = of_match_device(qcom_labibb_match, &pdev->dev);
+ if (!match)
+ return -ENODEV;
+
+ for (reg_data = match->data; reg_data->name; reg_data++) {
+
+ /* Validate if the type of regulator is indeed
+ * what's mentioned in DT.
+ */
+ ret = regmap_read(reg_regmap, reg_data->base + REG_PERPH_TYPE,
+ &type);
+ if (ret < 0) {
+ dev_err(dev,
+ "Peripheral type read failed ret=%d\n",
+ ret);
+ return -EINVAL;
+ }
+
+ if (WARN_ON((type != QCOM_LAB_TYPE) && (type != QCOM_IBB_TYPE)) ||
+ WARN_ON(type != reg_data->type))
+ return -EINVAL;
+
+ vreg = devm_kzalloc(&pdev->dev, sizeof(*vreg),
+ GFP_KERNEL);
+ if (!vreg)
+ return -ENOMEM;
+
+ vreg->regmap = reg_regmap;
+ vreg->dev = dev;
+ vreg->base = reg_data->base;
+ vreg->type = reg_data->type;
+
+ memcpy(&vreg->desc, reg_data->desc, sizeof(vreg->desc));
+ vreg->desc.of_match = reg_data->name;
+ vreg->desc.name = reg_data->name;
+
+ cfg.dev = vreg->dev;
+ cfg.driver_data = vreg;
+ cfg.regmap = vreg->regmap;
+
+ vreg->rdev = devm_regulator_register(vreg->dev, &vreg->desc,
+ &cfg);
+
+ if (IS_ERR(vreg->rdev)) {
+ dev_err(dev, "qcom_labibb: error registering %s : %d\n",
+ reg_data->name, ret);
+ return PTR_ERR(vreg->rdev);
+ }
+ }
+
+ return 0;
+}
+
+static struct platform_driver qcom_labibb_regulator_driver = {
+ .driver = {
+ .name = "qcom-lab-ibb-regulator",
+ .of_match_table = qcom_labibb_match,
+ },
+ .probe = qcom_labibb_regulator_probe,
+};
+module_platform_driver(qcom_labibb_regulator_driver);
+
+MODULE_DESCRIPTION("Qualcomm labibb driver");
+MODULE_AUTHOR("Nisha Kumari <nishakumari@codeaurora.org>");
+MODULE_AUTHOR("Sumit Semwal <sumit.semwal@linaro.org>");
+MODULE_LICENSE("GPL v2");