diff mbox series

[4/4] arm64: dts: qcom: sm8350: fix number of pins in 'gpio-ranges'

Message ID 20210303033106.549-5-shawn.guo@linaro.org (mailing list archive)
State Accepted
Commit 0d37f5077ffbb913a175dcb1b804e84d6bc67bd8
Headers show
Series Fix number of pins in 'gpio-ranges' | expand

Commit Message

Shawn Guo March 3, 2021, 3:31 a.m. UTC
The last cell of 'gpio-ranges' should be number of GPIO pins, and in
case of qcom platform it should match msm_pinctrl_soc_data.ngpio rather
than msm_pinctrl_soc_data.ngpio - 1.

This fixes the problem that when the last GPIO pin in the range is
configured with the following call sequence, it always fails with
-EPROBE_DEFER.

    pinctrl_gpio_set_config()
        pinctrl_get_device_gpio_range()
            pinctrl_match_gpio_range()

Fixes: b7e8f433a673 ("arm64: dts: qcom: Add basic devicetree support for SM8350 SoC")
Cc: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
---
 arch/arm64/boot/dts/qcom/sm8350.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sm8350.dtsi b/arch/arm64/boot/dts/qcom/sm8350.dtsi
index 5ef460458f5c..fab211298c35 100644
--- a/arch/arm64/boot/dts/qcom/sm8350.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8350.dtsi
@@ -382,7 +382,7 @@ 
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
-			gpio-ranges = <&tlmm 0 0 203>;
+			gpio-ranges = <&tlmm 0 0 204>;
 
 			qup_uart3_default_state: qup-uart3-default-state {
 				rx {